PDP-5070PU trap mode and no picture

[gica69]

I recently joined this forum and read an old post about the issue I am going through, I am stuck in the trap switch mode and do any get any screen glow, so the screen not lit at all. I opened the TV to fix the Ant A port that came off the board so I soldered it back and put everything together. Before I put the cover on I did try out to see if the Ant port would work(get signal) and from there the issue with the RED and BLUE lights. Also in the process I broke the D11 connector(actual latch type piece that holds the ribbon cable) from the main board to the CONTROL BOARD AWV2302-AWW1139(already ordered a new one). So I can still connect but not as sturdy as before. Besides the trap mode that could have set a code could anyone please let me know what it means if the screen is not lit at all when attempting to reset the trap switch. I thank you in advance.

[freakaftr8]

Re: PDP-5070PU trap mode and no picture

Unplug tv. Wait 20 seconds

1. Press the display button on remote then release the display button.
2. Wait between 3 and 7 seconds
3. On the remote press and release the <, ^, <, >, and power buttons in sequence.
Panel will now turn on in service mode.
4. Press muting button 3, 4 or 5 times until the display shows the initialize page.
5. Press and hold the display button until the error indicator (red LED) on either the panel or the media receiver goes out.
6. Exit service mode by pressing the power button on the remote.

This should work as I have made this mistake a few times myself lol