Re: e701i-a3 no picture but backlights
Well I forwarded the message to disconnect all the cables LVDS and locking flex cables from and to the panel and they say they did. They said it still has half a screen and that this happened once they cut the driver flex tabs. If tiny parts of these tabs left on the panel, could that cause that half of the screen to go out and if so how would you suggest I tell them to remove the rest? Can they be cleaned off with alcohol, laquerer thinner or acetone? This all happened because I think they thought they were being safe by only removing the boards in the beginning then putting it all back together pushing the driver tabs down making them hard to get at. I looked at the ones I removed and it looks like they are glued on with about a 1/6" strip of gray glue. If no the only thing I can think of is scraping with the edge of a razor blade? I wish I was there but I am 2000 miles away. I believe this panel is perfectly fine...
Well I forwarded the message to disconnect all the cables LVDS and locking flex cables from and to the panel and they say they did. They said it still has half a screen and that this happened once they cut the driver flex tabs. If tiny parts of these tabs left on the panel, could that cause that half of the screen to go out and if so how would you suggest I tell them to remove the rest? Can they be cleaned off with alcohol, laquerer thinner or acetone? This all happened because I think they thought they were being safe by only removing the boards in the beginning then putting it all back together pushing the driver tabs down making them hard to get at. I looked at the ones I removed and it looks like they are glued on with about a 1/6" strip of gray glue. If no the only thing I can think of is scraping with the edge of a razor blade? I wish I was there but I am 2000 miles away. I believe this panel is perfectly fine...
Comment