Announcement

Collapse
No announcement yet.

SONY KDL-V32XBR1 turns off after a few seconds

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    SONY KDL-V32XBR1 turns off after a few seconds

    when i first got this TV, it worked fine for a couple of days, though after so many hours, it would turn itself off, but if u turned it on again it would work again for another many hours...
    eventually though, the time between failures became less and less, and now it only works for a few minutes, or a few seconds before turning itself off.

    when plugged in but not turned on, there is no standby light.
    when power is pressed a green light comes on and the tv comes on.
    after a few minutes or a few seconds the screen turns off and a red light blinks 4 times over and over again.
    when power is pressed again, the light turns green and the set turns on for a second or two, then back to off and the red light blinks 4 times.
    if i turn the tv off before it turns itself off, i do not get any blinking lights, or standby light ( i think it doesnt do a red light for standby)

    just starting on this one...will do some more testing tomorrow
    Attached Files
    Last edited by triplefour; 09-18-2014, 06:52 AM.
    Don't fear the repair...

    #2
    Re: SONY KDL-V32XBR1 turns off after a few seconds

    oh wow i found the service manual and it says 4 blinks means a fan error. no big deal i just wait for it to shut down and see which fan is failing? all the fans seem fine...could there be something wrong with the sensor, or with the part that sends power to the fans?
    Last edited by triplefour; 09-19-2014, 01:46 AM.
    Don't fear the repair...

    Comment


      #3
      Re: SONY KDL-V32XBR1 turns off after a few seconds

      ok after messing with it for a while ive discovered which fan is acting up. the middle one refused to start. i switched connectors with the one next to it and it still wouldnt start. i took it out and tried to find another fan like it, couldnt find one.. started messing with the blades and wires...decided to put it back in, and now it works again... its probably going to mess up again before too long.. what can i do to refurbish this fan? or if i have to replace it, can i use just any case fan? this one has 3 wires...red, yellow, and black. im guessing black is ground. red must be the power because thats 6v and yellow must be the sensing signal that tells the computer whether the fan is spinning or not? anyway the yellow wire on the 2 fans that are fine read .01v and .02v but the yellow wire on the fan in question reads .29 ... whats going on there?
      Don't fear the repair...

      Comment


        #4
        Re: SONY KDL-V32XBR1 turns off after a few seconds

        well i guess it doesnt matter cause i found a fan that could replace it and now it seems everything is fine. gonna let it run for a day or 2 and see
        Don't fear the repair...

        Comment

        Working...
        X