Toshiba 32DT2U1 has 5v but no stby LED, wont power on

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • triplefour
    Badcaps Legend
    • May 2014
    • 1747
    • USA

    #21
    Re: Toshiba 32DT2U1 has 5v but no stby LED, wont power on

    im stumped
    Don't fear the repair...

    Comment

    • triplefour
      Badcaps Legend
      • May 2014
      • 1747
      • USA

      #22
      Re: Toshiba 32DT2U1 has 5v but no stby LED, wont power on

      would appreciate any suggestions! ...and i really cant find the service manual for this one
      Last edited by triplefour; 09-03-2014, 05:56 AM.
      Don't fear the repair...

      Comment

      • triplefour
        Badcaps Legend
        • May 2014
        • 1747
        • USA

        #23
        Re: Toshiba 32DT2U1 has 5v but no stby LED, wont power on

        any ideas before i junk this one??
        Don't fear the repair...

        Comment

        • triplefour
          Badcaps Legend
          • May 2014
          • 1747
          • USA

          #24
          Re: Toshiba 32DT2U1 has 5v but no stby LED, wont power on

          well i revisited this one today and i guess it just needed to rest because now its at least turning on when i press power. steady green light. and i was even able to hook up my n64 and hear some sound and when i shine a bright light at the screen i can see the graphics. i have 24v going to the inverter, but im guessing the inverter is just not doing its job.
          i dont even get a flash.
          there are 4 voltage regulators on the inverter, 2 of them read all zeros, the other 2 read all zeros except the middle pin/tab which reads 24v
          does that seem right?
          Don't fear the repair...

          Comment

          • triplefour
            Badcaps Legend
            • May 2014
            • 1747
            • USA

            #25
            Re: Toshiba 32DT2U1 has 5v but no stby LED, wont power on

            heres some pics of the inverter.

            i got 24v on the positive legs of both electrolytic capacitors
            i got 24v on the fuse
            i got 0v on the smd capacitors
            i got 0v on all the legs of the IC's except 15v on one of the legs of the 4 leg IC
            Attached Files
            Don't fear the repair...

            Comment

            • triplefour
              Badcaps Legend
              • May 2014
              • 1747
              • USA

              #26
              Re: Toshiba 32DT2U1 has 5v but no stby LED, wont power on

              aaaaaaaand its back to being broken again. after working fine (except for backlight) for a couple hours, i turned it off to check the resistances on the transformers and when i turned it back on, the green light would come on for about 5 seconds then just turn off. non standby voltages would come up on the board and then die away with the green light. i decided to jump the power supply without the motherboard connected, and that worked. all voltages were present but still no backlight.
              when i tried to hook the motherboard back up though, now i dont get a green light..it just gets stuck in "on mode" as soon as i plug it in...voltages are there but the motherboard must be crashed cause i cant hear sound or change source or anything...so it seems like my psu is fine, my inverter has a problem, and my motherboard has an intermittent problem...

              oh yeah the resistances on the transformers were all infinite except for the 2 pins in the middle on the psu side of the board...those are 0 resistance. doesnt seem right to me. maybe theres a coating over the pins that i need to scratch away to get a better reading..
              Last edited by triplefour; 09-21-2014, 07:56 AM.
              Don't fear the repair...

              Comment

              • triplefour
                Badcaps Legend
                • May 2014
                • 1747
                • USA

                #27
                Re: Toshiba 32DT2U1 has 5v but no stby LED, wont power on

                after letting the tv sit for a few days, it was able to turn on again as before, and get sound and see graphics but still no backlight. since i found an inverter for only 12$ on ebay i decided to get it... but i guess i still have some kind of motherboard problem because after turning the tv off after running it for a while, its back to showing the green light for about 5 seconds and then turning off again...what could be happening here? some kind of eeprom that clears itself after being without power for long enough?

                i was able to turn the tv on and off again just fine a bunch of times. but after i let it run for about 30 minutes, i powered it off and was not able to get it to power back on again. just the green light for 5 seconds. then eventually not even the green light will come on...ill let it sit for another day or 2 and see what happens.
                Last edited by triplefour; 09-29-2014, 12:13 AM.
                Don't fear the repair...

                Comment

                Related Topics

                Collapse

                • Capacitorial
                  Powersupply has all the voltages - Monitor still no power
                  by Capacitorial
                  Hello guys,

                  I have a Philips 240B7QPJEB. The monitor seems completely dead.
                  I opened it and measured the voltages of the powersupply. I found that a mosfet was dead and replaced it.
                  On the connector, that goes to the TCON board, all voltages 15-19V and 5V are present.
                  The small connector on the left of the PSU has two cables with 18V and all the other have 0.2V. It connects on this small connector on the left ontop of the panel. I guess the backlight? Seens fine I guess.
                  The weird thing is, that the Power LED is powered over the TCON board.
                  On The TCON...
                  12-28-2024, 02:12 PM
                • sam_sam_sam
                  Desoldering gun station modified to use a 18 volt @ 20 amp switching power supply
                  by sam_sam_sam
                  I have wanting to do this project for quite sometime now and I finally found a switching power supply that will work on this desoldering gun station ZD-915 that the original switching power supply took a shit and just was not worth trying to fix it because this switching power is not quite big enough to handle the heater element and the vacuum pump

                  One note when I tested the switching power supply and the voltage control board I noticed that this desoldering gun heat up much faster than the original switching power supply which I was really surprised by to the point that I might buy...
                  03-31-2024, 02:12 PM
                • ju123
                  Toshiba Satellite C50-A won't power down
                  by ju123
                  Hi guys,

                  So, I've been racking my brains on this one.

                  I have a Satellite C50-A which I'm repairing for a friend.

                  I recently replaced the main board due to failure.

                  Following this, absolutely everything works perfectly, except for the fact it won't power down.

                  Initially, shutting down via Windows would shut the OS down, screen would turn off (noticed the lighter black go to what looks like the darker black powered off screen as though the backlights have powered off), however the laptop was still running internally with a spinning...
                  01-07-2022, 04:40 PM
                • Tynan Dill
                  Vizio e601i-A3 - Has Sound and Display, But No Backlight - Bad Power Supply Board or Bad LED Bulbs ?
                  by Tynan Dill
                  I was given this TV from my great uncle. He said it just wouldn't turn on one day out of nowhere, replaced the TV, and gave it to me to possibly fix and use for myself.

                  Upon bringing it home and plugging it up, it showed a standby light.

                  I powered it on and without a flashlight, the display showed the "V" but the lighting is very dim, but visible.

                  The screen seems to blackout and stay black, but with a flashlight I can see the display.

                  With my Playstation 4 connected via HDMI, and running a game I can hear sound.

                  Assuming...
                  11-22-2024, 01:46 PM
                • Document Archive
                  HP Pavilion Power Pavilion Power 15-cb009nl Notebook 15 Specification for Upgrade or Repair
                  by Document Archive
                  This specification for the HP Pavilion Power Pavilion Power 15-cb009nl Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Pavilion Power 15-cb009nl boardview and Pavilion Power 15-cb009nl schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that...
                  09-06-2024, 05:59 AM
                • Loading...
                • No more items.
                Working...