Hello,
About 6 months ago the colors on my Samsung LN40A500T1FXZA suddenly became inaccurate (see attached photo). I did a factory reset, and swapped out the logic board (or what I think is the logic board – it has the coax and HDMI connectors built in) as I had a spare (I broke the RF connector off my original board). Neither of these changes had any effect. I was able to make the picture tolerable by going into the service menu and changing “gamma” from default (1.0 I think?) to 0.85 (see second picture) and changing the normal picture controls.
I have decided I would like to fix the TV. After reading some posts on this site, I think I need a new T-CON board or gamma IC. My gamma values are:
1: 14.99
2: 12.83
3: 12.04
4: 11.13
5: 10.73
6: 10.39
7: 9.97
8: 9.10
9: 8.10
10: 6.92
11: 6.43
12: 6.53
13: 9.90
14: 9.28
15: 6.11
16: 3.72
17: 2.52
Unlabeled pad: 0.40
Do you think my gamma IC is bad? If so, can you recommend a supplier for the gamma IC (AS19-H1G 0822 B8308?27), or preferably the whole T-CON board. I do not think my soldering skills are up to replacing the gamma IC, so I would prefer to replace the whole board unless the cost is prohibitive.
I have also attached two pictures of my T-CON board.
Thanks!
Chris
About 6 months ago the colors on my Samsung LN40A500T1FXZA suddenly became inaccurate (see attached photo). I did a factory reset, and swapped out the logic board (or what I think is the logic board – it has the coax and HDMI connectors built in) as I had a spare (I broke the RF connector off my original board). Neither of these changes had any effect. I was able to make the picture tolerable by going into the service menu and changing “gamma” from default (1.0 I think?) to 0.85 (see second picture) and changing the normal picture controls.
I have decided I would like to fix the TV. After reading some posts on this site, I think I need a new T-CON board or gamma IC. My gamma values are:
1: 14.99
2: 12.83
3: 12.04
4: 11.13
5: 10.73
6: 10.39
7: 9.97
8: 9.10
9: 8.10
10: 6.92
11: 6.43
12: 6.53
13: 9.90
14: 9.28
15: 6.11
16: 3.72
17: 2.52
Unlabeled pad: 0.40
Do you think my gamma IC is bad? If so, can you recommend a supplier for the gamma IC (AS19-H1G 0822 B8308?27), or preferably the whole T-CON board. I do not think my soldering skills are up to replacing the gamma IC, so I would prefer to replace the whole board unless the cost is prohibitive.
I have also attached two pictures of my T-CON board.
Thanks!
Chris
Comment