I have been working on this Daytek Plasma, it's basically a LG. All LG parts.
I can't adjust the Vzb on the Zsus. Doesn't do anything. No picture adjustment.
I adjusted the pots the best I can to get a clear picture. I finally got one but the whites are low and the readings are all out of whack.
The panel sticker says the Vs should be 189v and I have 171v.
The panel sticker says the Vy should be 75 and I have 93v.
The panel sticker says the Va should be 65v and I have that.
The panel sticker says the Vsc should be 115v and I have that.
The panel sticker says the Vsetup should be 200v and I have that.
Is the tv ok to run the Vs at 171v and the Vy at 93v?
If I set them to the proper numbers my picture is full of green and red pixels.
I can't adjust the Vzb on the Zsus. Doesn't do anything. No picture adjustment.
I adjusted the pots the best I can to get a clear picture. I finally got one but the whites are low and the readings are all out of whack.
The panel sticker says the Vs should be 189v and I have 171v.
The panel sticker says the Vy should be 75 and I have 93v.
The panel sticker says the Va should be 65v and I have that.
The panel sticker says the Vsc should be 115v and I have that.
The panel sticker says the Vsetup should be 200v and I have that.
Is the tv ok to run the Vs at 171v and the Vy at 93v?
If I set them to the proper numbers my picture is full of green and red pixels.