No picture issue in Philips Chassis FTL2.1

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • charlesdutcher
    New Member
    • Aug 2024
    • 1
    • United States

    #1

    No picture issue in Philips Chassis FTL2.1

    Hello,
    My Plasma Philips 37inch chassis FTL2.1 does not show picture. It automatically goes into protection mode after 30 seconds (red led blinks at 3Hz)


    Is there someone having any symptom like this? How to fix it?

    Thanks in advance!​

Related Topics

Collapse

  • CyberPhoenix
    Issue with picture quality of Sony bravia TV
    by CyberPhoenix
    Hello, Last week I bought the 50" Sony X80j tv everything was working fine, untill I plugged the tv in a ups power supply 650va the tv remote control became unresponsive and the TV became laggy after a while the picture quality isn't the same as before the tv seems less brighter and the picture is somehow blurry, people's faces don't look as natural as before, there is a mini orange-pink tint to the edge of people's faces especially in NETFLIX Dolby Vision like in One Piece ep1 Alvida skin tone, my intention was to protect the tv but something went wrong I checked the ups with a multimeter,...
    01-22-2024, 02:08 AM
  • madyoyo
    Philips 37pfl560: Yellow picture
    by madyoyo
    HI.

    I have a weird problem with an old Philips 37pfl560 TV i put out of storage: the picture have a noticeable yellow hue, and its not caused by the settings (did a factory reset). I've never seen this before. I will try to get a photo with a real camera, with my phone its hard to see because of automatic white balance, but in real live the whites are really yellow.

    Anyone have an idea of what can cause this? Can CCFL tubes get "warmer" with time? This tv have several analog inputs,so its nice for retrogaming....
    05-30-2025, 10:16 AM
  • Tr0ll
    T-con suspect issue. Both ribbon cables no picture. One ribbon cable ok. (58pus8545)
    by Tr0ll
    Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.

    The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.

    Original T-con:
    Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.

    First replacement T-con:

    I thought it might be t-con and ordered new t-con from china(supposedly tested)...
    10-07-2023, 07:48 PM
  • ovrax
    Philips 55PUS6804/12 turn on & off (probably backlight issue)
    by ovrax
    Hello everyone,

    First of all, please excuse me as I'm quite new to this field.

    I have a Philips 55PUS6804/12 TV. It turns on and off instantly (backlight flash). I personally think it's a backlight issue (faulty LEDs). Could you help me confirm my diagnosis?

    I've checked and the T-CON seems to be fine. I disconnected one ribbon cable at a time at the bottom, but the problem persists.
    The Ambilight works perfectly and stays on.

    No sounds.

    Thanks in advance.
    08-25-2024, 04:33 AM
  • groomit
    Philips 50PUS7363/12 Backlight but no picture
    by groomit
    Hi,
    I'm having trouble with above mentioned TV. Bought it defect.
    Picture was heavily compressed around the horizontal axis. Fiddeled and tried different things (mask clock lines, swap T-Con). But no difference.
    Then I identified a heating capacitor on the left hand Signal-PCB (?) below the display. Replaced it by hand soldering. Checked for shorts afterwards. But now the screen stays black.

    I can see backlight, but screen stays black.
    What I've tried:
    - Disconnect right side cable from T-Con -> same (backlight but no pic)
    - Disconnect left side...
    11-22-2024, 02:43 PM
  • Loading...
  • No more items.
Working...