Samsung Panel Repair Questions

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • dnafix
    New Member
    • Oct 2012
    • 8
    • United States

    #1

    Samsung Panel Repair Questions

    Working on several Samsung panels that all have the same problem. The problem is inside the panel and is similar to the power problem that causes the white screen such as on this magnavox panel. Almost certainly it is one of the voltages that feeds the tft's because all the signals check out between a good one and a bad one except for a signal that comes out of the board that may be called stvp or hgt. The diagram shows the good and the bad panel and the signal voltages and the feedback signal in question is the fourth from the right.

    Two panel testpoints

    Here are some other panels that I have worked on that have a similar problem but also have tabs along the side to bypass the inner wiring that has opened.
    Magnavox Panels

    The panel is from a Samsung Hospitality unit HG32NA477
    Because of the frequency of which these are failing it seems that someone would know about this. Also perhaps there is an alternate pin that whatever missing voltage might enter similar to what was done in the magnavox's above.
    Last edited by dnafix; 02-26-2014, 11:03 PM.

Related Topics

Collapse

  • Document Archive
    Samsung Galaxy Book 2 Notebook Specification for Upgrade or Repair
    by Document Archive
    This specification for the Samsung Galaxy Book 2 Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Galaxy Book 2 boardview and Galaxy Book 2 schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet, or download...
    09-07-2024, 05:50 AM
  • triplefour
    SAMSUNG UN50TU8000F rebooting, backlight ok. No 12v to panel boards.
    by triplefour
    TV flashes backlight then reboots over and over. no image. Client said it used to have image for a bit before rebooting. Got worse over time.

    tcon is built into mainboard.
    Only one cable goes to panel boards.
    there is a cable from one panel board to the other that links them.
    cost cutting measure that results in us having harder time to diagnose.
    removing the link to the second panel board allows TV to stay on with stable backlight but no image.
    used cut off tape method to mask 1 maybe 2 pins on the side of the cable that goes to that second panel board....
    07-28-2022, 07:59 PM
  • NolesFan
    Can LED panels be used from different TV's ( or the internals to the panel )?
    by NolesFan
    I have a TV, ( example ) Sony XBR-75X80G that the LED panel is cracked, does anyone know if we can take the LED panel from a ( example ) Sony XBR-75X80H and plug it in and it will work? Or if the panel measurements is not exact, can we take the internals of the cracked panel 80G TV and mount into the good panel 80H TV? Thank you
    06-23-2025, 09:19 AM
  • KYBOSH
    Samsung UN50TU8000 - Dead Panel Forensic Questions
    by KYBOSH
    I came across a 50inch TU8000 that wouldnt start up properly (blinking stand-by light, backlights would cycle on and off).





    When i opened it up and removed the power to the mainboard the backlights powered up and everything looked uniform.
    When reconnected the mainboard but disconnected the flex cable to the panel i heard the TV startup with the intro sound.






    Later I checked for shorts on the panel PCB boards but could not find anything.
    When I took a look with the FLIR i noticed the 2 resistors...
    08-10-2024, 08:39 AM
  • Ierwin
    Samsung GU50TU8079U bad panel diagnosis
    by Ierwin
    Hello,

    I was given this Samsung GU50TU8079U that would power cycle after a couple seconds, sometimes a few minutes. The screen would turned cloudy dark with the backlight still lit and then the sytem would restart.
    Its one of the newer screwless Samsung models that I read a lot about panel failures here. It does not have a sperate T-CON board, just one ribon from the mainboard to the panel board and a U-shaped ribbon cable connecting the other half.
    I went through the usual diagnostics:
    unplugged the mainboard -> tv stayed on
    removed the U-Shape robbon ->...
    11-11-2023, 05:09 AM
  • Loading...
  • No more items.
Working...