Samsung ue32d4003bw: Blinking Stand-by Light

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • speedypro
    Badcaps Veteran
    • Feb 2013
    • 561
    • United Kingdom
    #1

    Samsung ue32d4003bw: Blinking Stand-by Light

    I have opened the tv up and saw a swollen cap and a shorted diode. Diode model is SR315A. Could not find much about it but I saw somewhere it reads 3A, 100V so I replaced it with diode 1N5401 (3A, 100v), but still same blinking red light. Cap was a 68uf, 200v. Replaced with 68uf, 250v.

    Would anyone of the above still cause the blinking red light?
    Full-time computer repair tech (10am - 6pm) and full-time, (8am - 11pm), Ruby on Rails Developer
    Tags: None
    Previous template Next

    Related Topics

    Collapse
    • ChristianBr01
      LED TV Samsung The Frame 55 inch QE55LS03RAU Standby Light only
      by ChristianBr01
      Hello everyone,
      I got a Samsung The Frame 55 inch TV for free from uncle cause it is not turning on anymore. I am in the second year of training as an electrician so I have knowledge already but I am far away from to be a pro.
      The TV has Standby but ist not turning on. A Friend of mine owns a 50 inch Frame TV so I checked the One Connect Box and the One Connect Cable there. Both are good and working normally. I have opened the TV case and measured some voltages on the Board.
      What I already found is that the 12.8V are not an the connector to the main board connector to the power...
      04-23-2025, 01:48 AM
    • Kaar3l
      Samsung QLED QE65Q7FNAT only standby light
      by Kaar3l
      TV: Samsung QLED QE65Q7FNAT
      PSU: BN4400940A
      MB: BN94-12832K

      I got the tv in spring 2024. At that time it started, then ran 60 sec and poweroff. Seemed like reboot issue. I didn't have time and room to check it in summer so I plugged it in and now the standby light is on. I press button on remote, standby light goes off and tries to start?. No picture or backlight on LCD. I thought about removing diodes like in this thread: https://www.badcaps.net/forum/troubl...sung-qled-q60r...
      09-24-2024, 01:35 PM
    • Nicktronic
      Samsung UN70NU6070F Standby Light flashes twice
      by Nicktronic
      Hey Everyone,

      So I've got this Samsung and the reported issue is that when powered on the backlight comes on, but no picture, no sound, it will flicker, the standby light will flash red twice and repeat the whole process...each loop lasts about 15 seconds.

      I've googled the issue and understand it is likely a panel/driver board issue, but was hoping the "tape method" could be successful. Before I did that though, I disconnected the left LVDS cable and powered the TV on. This time I got sound, no picture and the two blink standby light stopped. Did the same...
      03-27-2023, 07:01 PM
    • marcinq
      Samsung UE60KS7000 No Standby Light
      by marcinq
      Hello,

      I've got a problem with a Samsung UE60KS7000 that was given to me and said that there was a problem with the One Connect box but as I understand the TV should turn on even with the One Connect box disconnected (which it doesn't). There is no stand by light.

      I've disconnected the Main Board from the PSU and when connecting to mains the backlight turns on which suggests the PSU might be ok. I've measured the voltages out of the PSU and they seem reasonable (like the labels say). The main board has no obvious burns, there are no shorts on the power rails anywhere....
      4 Photos
      05-26-2025, 11:36 AM
    • SJX1290
      No Standby Light on Samsung SAMSUNG UE65NU7022
      by SJX1290
      I have Samsung UN65MU6300FXZA with Mainboard BN41-02662A, dead , No Standby Light. I suspect result of main power jumping. Checked all voltages on main board ok,..
      My main suspect is bad flash memory, ...
      Any suggestions or can someone please​ check dump file, in the attachment
      Thank you...
      09-07-2024, 01:35 AM
    • Loading...
    • No more items.
    Working...