lg 50pg4000 loses sound remote stops working and switches off

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • tom66
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    Well as the fault is caused by it running for a long time, and hence heat likely, then a hairdryer will probably make the problem worse. If you can't do a factory reset then there is no option but a board swap.

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    cant even try factory reset from service menu as cant get in just yet takes ages to get the remote working

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    tom got a hairdryer is it worth trying it

    Leave a comment:


  • tom66
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    Which indicates it's receiving the instructions but discarding or ignoring them - the main board is at fault. On some of these main boards, there's a SUB MICOM for processing IR, standby and LED functions. The SUB MICOM connects to the main processor by I2C interface, typically. If there's a problem with the main processor or the interface, this effect might be observed.

    As for repair? Main board swap is probably the only thing that can be done.
    Last edited by tom66; 09-26-2013, 02:38 AM.

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    Originally posted by Ltank
    The remote board wires go to a different section of the main board that the audio. If it goes out after warmed up, I would try freeze spray on the voltage regulators and audio chip. When the audio drops out what is the voltage to the chip? The preamp IC has a lower voltage than the audio amp. Check both while your there. Do you loose the power to the IR remote rcvr facing the front of the set? I am responding from my phone so I am unable to look at a schematic.
    once I lose sound the remote works tv led flashes to show this but will not do the functions pressed
    Last edited by wreksta; 09-26-2013, 02:29 AM.

    Leave a comment:


  • Ltank
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    A fast and easy test is to unplug the IR from the main board and use the buttons on the set for on/off and volume up/down. If the board is bad it can cause these problems

    Leave a comment:


  • Ltank
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    The remote board wires go to a different section of the main board that the audio. If it goes out after warmed up, I would try freeze spray on the voltage regulators and audio chip. When the audio drops out what is the voltage to the chip? The preamp IC has a lower voltage than the audio amp. Check both while your there. Do you loose the power to the IR remote rcvr facing the front of the set? I am responding from my phone so I am unable to look at a schematic.

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    cant get remote working now at all meaning none respondant

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    it does mate ill try that

    Leave a comment:


  • tom66
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    That may or may not cause issues, but sounds like the board has been previously replaced.
    One other thing to check is if the set has a separate board for the buttons try disconnecting that.

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    im trying but cant get damn remote to work again


    heres a thing its a 50pg4000 but it has the pg6000 main board in
    Last edited by wreksta; 09-25-2013, 05:41 PM.

    Leave a comment:


  • tom66
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    You don't own a hairdryer?
    LVDS, Y-sus, Z-sus, Y-buffer, panel etc wont have anything to do with sound.
    Only possibility is PSU or Main, and you ruled out PSU.
    Try service reset from service menu before you swap main.

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    I only have a heatgun tom I could use low setting but where would I try heating up



    so you think x and y are fine ldvs and all buffers are ok you think main board

    Leave a comment:


  • tom66
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    I'd suggest heating up things as well to see if it's a main board fault. I think main board fault is extremely likely.

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    ill have to wait as failure has occurred so remote or sound don't work

    Leave a comment:


  • tom66
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    At all, or when failure occurs?

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    headphone not working nor is my 2.1 Logitech pc sound system

    Leave a comment:


  • tom66
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    Menu on buttons, Menu on remote. Hold for 10 seconds. If password pops up, enter 0000 or 1234.

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    how to get service mode on this set mate

    Leave a comment:


  • wreksta
    replied
    Re: lg 50pg4000 loses sound remote stops working and switches off

    lol cheers tom I feel daft now I thought you meant check volts or something I have headphones yes

    but no soundbar or av receiver

    Leave a comment:

Related Topics

Collapse

  • LEECH666
    Grundig Vision 9 37 9880 T USB (Chassis SR) TV Repair Help - Distorted Subwoofer Sound and overall weird sound waveforms
    by LEECH666
    Good day ladies and gentleman!

    I am currently trying to repair a Grundig Vision 9 37 9880 T USB LCD TV for a friend that has a weird audio problem. Basically everything works fine except for the heavily distorted sound when the Subwoofer module is connected and there is a buzzing sound coming from the PSU PCB.

    This seems to be a rather rare TV so there is not much prior on topic help to be found however a service manual is available at the usual sources (Electro Tanya i.e.).

    I think the PSU buzzing comes from one of the coils near the bridge rectifier but...
    01-19-2024, 05:46 PM
  • laidman
    Yamaha psr ew400 piano loses sound
    by laidman
    Yamaha PSR EW400 piano intermittently loses sound and shuts down.

    Youtube people recommend verifying that the DC jack's solder connections aren't broken, and the replacement of a couple of capacitors in the vicinity of the DC jack. While these solutions might work, I'd feel a lot more secure if I had a schematic to help me check the status of the myriad components.

    Schematic and suggestions are welcome.
    11-18-2023, 05:13 PM
  • Christos Tsiligiannis
    Marian Trace Alpha sound card repair help
    by Christos Tsiligiannis
    Hello to the forum.

    My name is Christos, I am new to the forum here and i am posting from Greece.

    So i have this old German sound card from Marian, called Trace Alpha. To be exact i have 2 of them and i use them professionally for my small FM radio station here. The first one works like a charm, but the second one does not work at all.

    To be more specific in the same exact pc with windows 7 (i even tried 32bit) the one works while the other doesn't.

    So i tried asking for a schematic from the company and they would not give me one. Instead they...
    11-18-2024, 05:26 AM
  • ChaosLegionnaire
    what i went through dealing with my mobo with dead onboard sound!
    by ChaosLegionnaire
    so i took out one of my spare gigabyte ep35-ds3r mobos from storage for use to do some cpu, ram and video card testing of stuff i bought from ebay and got for free from momaka. he bought 50 e8400 cpus for cheap from ebay some years ago and i decided to help him relieve him of some of his supply since he had waaaay too many!! what did we say about hoarding too much stuff and depriving others of them?! *cough* socialism *cough* lol!

    i had to blow some dust off the board and heatsinks with the datavac as i didnt clean it up before putting it in storage. after finishing...
    09-13-2022, 09:02 AM
  • Document Archive
    HP ProDesk 600 G5 + LG SJ2 Bluetooth Sound Bar ProDesk 600 i5-9500 Specification for Upgrade or Repair
    by Document Archive
    This specification for the HP ProDesk 600 G5 + LG SJ2 Bluetooth Sound Bar can be useful for upgrading or repairing a desktop PC that is not working. As a community we are working through our specifications to add valuable data like the ProDesk 600 G5 + LG SJ2 Bluetooth Sound Bar boardview and ProDesk 600 G5 + LG SJ2 Bluetooth Sound Bar schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please...
    09-12-2024, 02:30 PM
  • Loading...
  • No more items.
Working...