Samsung LE32R88BD/ BN44-00155A

[budm]

Re: Samsung LE32R88BD/ BN44-00155A

Please up load pictures of the whole backside of the TV so we can clearly see all the boards and also the pictures of the T-CON board.

[darth]

Re: Samsung LE32R88BD/ BN44-00155A

[budm]

Re: Samsung LE32R88BD/ BN44-00155A

LE32RB86BDX-SPD as i'n first post.

That is NOT the LCD panel model number.

[darth]

Re: Samsung LE32R88BD/ BN44-00155A

LE32RB86BDX-SPD as i'n first post.

[budm]

Re: Samsung LE32R88BD/ BN44-00155A

Those two are NOT fuses, they are Ferrite inductors.
What is the LCD panel model number as printed on the sticker?

[budm]

Re: Samsung LE32R88BD/ BN44-00155A

Are you referring to these two components?

[darth]

Re: Samsung LE32R88BD/ BN44-00155A

I measured these two right under connector on image. Hope i'm on right place.

[budm]

Re: Samsung LE32R88BD/ BN44-00155A

So there are two smd fuses above tcon cable which goes from main. On both end of both fuses is 5.26V in power on state.

Is there something known to causing this or there is need for replace main completely?

Can I see the pictures of these two fuses?

[darth]

Re: Samsung LE32R88BD/ BN44-00155A

So even with t con disconnected there is same low voltage on fuses so problem must be on main. There is one FET near connector, should i try to change it only?

[michael dranfield]

Re: Samsung LE32R88BD/ BN44-00155A

You should have 12 volts on the T con fuse, if you trace the power to the main board it usually comes from a switching transistor or FET whch is either faulty or for some reason has a low input, another thing you could try is disconect the T con board and see if the rail rises up just in case a short on the T con is pulling the rail down.

[darth]

Re: Samsung LE32R88BD/ BN44-00155A

So there are two smd fuses above tcon cable which goes from main. On both end of both fuses is 5.26V in power on state.

Is there something known to causing this or there is need for replace main completely?

[budm]

Re: Samsung LE32R88BD/ BN44-00155A

Hi guys,

looking for some advice on fixing my mom's LE32RB86 LCD TV. It powers on, remote, backlight and sound works, but there is no picture just backlighted black, otherwise everything ok.

Unfortunately doesn't seems like standard caps power on problem.

Do you have some experience if it could be some parts, because whole boards seems so rare on that old tv.

Thanks for advice.

Did you check to find out if the SMD fuse on the T-CON board has abot 12VDC at both ends of the fuse with ref. to the chassis (GND)?

[michael dranfield]

Re: Samsung LE32R88BD/ BN44-00155A

Another very common problem with this board apart from the conductive glue is dry joints on the transistor just above where the mains enters the board, you need to re solder this item every time one of these sets comes in for repair as it can lead to intermittent faults.

[darth]

Re: Samsung LE32R88BD/ BN44-00155A

Hi guys,

looking for some advice on fixing my mom's LE32RB86 LCD TV. It powers on, remote, backlight and sound works, but there is no picture just backlighted black, otherwise everything ok.

Unfortunately doesn't seems like standard caps power on problem.

Do you have some experience if it could be some parts, because whole boards seems so rare on that old tv.

Thanks for advice.

[budm]

Re: Samsung LE32R88BD/ BN44-00155A

Thanks for the follow-up.

[veaux]

Re: Samsung LE32R88BD/ BN44-00155A

I would replace those parts as listed at this point.

Alright!!! I ordered all the parts and just replaced them. (Both mosfets, the fuse resistor, the kV cap and the box cap). It works like a charm now!

Thank you budm !!!

[Loz2212]

Re: Samsung LE32R88BD/ BN44-00155A

Any suggestions guys?

Loz.

[LPs1978]

Re: Samsung LE32R88BD/ BN44-00155A

Can we see the pictures of your main board? More likely you have bad SMD caps on the main board that the ESR will go down when heated up so the board function again.
Since it is not the same model as in this thread, you should start a new thread.

Ok. Thank you.
I'll start a new thread.

[Loz2212]

Re: Samsung LE32R88BD/ BN44-00155A

Hope this is OK. Thanks

[Loz2212]

Re: Samsung LE32R88BD/ BN44-00155A

Struggling to upload photos for some reason..

Thanks for the response. The power supply is a BN44-00155A.

Thank you.