Need help just bought this cheap Laser printer.
They all now come with these chips to limit refilling.
Anyway I remove the chip but it has this black blob over the chip. I was hoping to remove the black stuff off to see what chips it uses to read the contents.
I tried heating it up with heat gun a bit and it does not melt at all, it's rock hard.
I have a EETools Topmax programmer, but without any info on what the 4 pins do, don't know if I will be able to read the chip information.
What I'm asking is has anyone have any ideas ho to tackle this.
attached pic of chip
They all now come with these chips to limit refilling.
Anyway I remove the chip but it has this black blob over the chip. I was hoping to remove the black stuff off to see what chips it uses to read the contents.
I tried heating it up with heat gun a bit and it does not melt at all, it's rock hard.
I have a EETools Topmax programmer, but without any info on what the 4 pins do, don't know if I will be able to read the chip information.
What I'm asking is has anyone have any ideas ho to tackle this.
attached pic of chip
Comment