Hi,
Does anyone have the absorber reset software for the Canon MG3650S?
thx
Does anyone have the absorber reset software for the Canon MG3650S?
thx
-
Hello all!
My maintenance cartridge tank unfortunately is "full". Can anybody help me to reset it? I have the dump file read from the 4g16 chip.... -
Hi Anyone has dump from working canon mg2555s i got error 5B00
I would like to try flash eeprom witch ch341a09-14-2024, 04:25 AM -
hi,
I've here this printer that is "locked" because Ink Absorber waste ink Counter is full so when I power on it give a sequence of 7 blinking orange LED in sequence with green power ON led.
Reading a lot over Internet it seem that is an "use&trash" model so there isn't a way to reset manually this counter and also seems that it is not possible to enter in Service Mode status to reset with Canon Service Tool utility.
This is really suck because I cleaned already the printer and bought both new cartridges!!!
Working around for a while I finally... -
hi i need dump canon mx475 UE versión. Not entry in service mode, need reset absorber. thanks
05-09-2025, 11:15 AM -
I am a hobbyist (not a professional) so please be gentle...
I recently received an XR-77A80J that wouldn't turn on. (Repeating 5 flashes when plugged in.)
I did a hard reset by holding the power button for about 30 seconds until the set powered down. I then tried to turn it on and it powered up, bringing me to the setup screen. There's not a lot of detail on the setup screen but the picture didn't have any distortions, so at least a cursory examination suggests no physical damage to the screen. The set appeared to be working normally, but it shut down after about 15 seconds,...
Comment