What is this component pls ? (power Nikon D5)

[lotas]

Re: What is this component pls ? (power Nikon D5)

Corrize This is from a prior post from lotas to which you did not respond. He is telling you that you are comparing different microcircuits. He is actually saying that it is not correct to do.
One response you could have used was, Oh I did not know that can you help me figure out what is wrong.

It's too late, when dismantled, the motherboard cannot be repaired.

https://www.badcaps.net/forum/showthread.php?t=107949

[keeney123]

Re: What is this component pls ? (power Nikon D5)

It's too late, when dismantled, the motherboard cannot be repaired.

https://www.badcaps.net/forum/showthread.php?t=107949

Thank you I had no idea.

[keeney123]

Re: What is this component pls ? (power Nikon D5)

To Corrize,
Lotas say the board cannot be repaired. He provided me another thread that about you and this unit. My suggestion to you is if you ever come across a different unit that has troubles do not just try to fix it first. You would need to ask help first and listen to a procedure that a technician can provide. It is kind of like learning to walk before you run.

[corrize]

Re: What is this component pls ? (power Nikon D5)

Lol, who said the board can’t be repaired ? A new chip and diode had ordered, and the board will work fine.
In the other thread, I was scared to destroy chemical cap with hot air, but look the last pictures… it’s not a cap, it’s a coil ! So all is good.

My first job (there is so long time) was electronic engineer, I made test boards for R&D, but with crossings components, LM555, etc. I’m not updated but don’t worry, I guess I know a little what I do. I’m not a repair shop, I repair because I like repair nice stuffs, this camera is for my family, it is not so new as pictures, it’s in very bad state, it was dropped as I said above, it’s professionnal use is definitly end.

[keeney123]

Re: What is this component pls ? (power Nikon D5)

Lol, who said the board can't be repaired ? A new chip and diode had ordered, and the board will work fine.
In the other thread, I was scared to destroy chemical cap with hot air, but look the last pictures… it's not a cap, it's a coil ! So all is good.

My first job (there is so long time) was electronic engineer, I made test boards for R&D, but with crossings components, LM555, etc. I'm not updated but don't worry, I guess I know a little what I do. I'm not a repair shop, I repair because I like repair nice stuffs, this camera is for my family, it is not so new as pictures, it's in very bad state, it was dropped as I said above, it's professionnal use is definitly end.

One question I have is if you were and electronic engineer why you would then need help with this unit?