Hello all. This is probably a long shot but I am hoping someone out there can help me. I have a Pro-Logic PL2510 smart battery charger that doesn't work. It goes though its start up routine but will not display the proper batty voltage when a battery is connected. There is not allot of electronics on the board so I decided for the $3, I would replace the 3 integrated circuits. No change in operation. The MCU is a PIC18F25k22 and I was able to extract the HEX code and reinstall it into the new IC. There is a programming header on the circuit board. After experimenting putting in different voltages I come to the conclusion that the MCU is not calculating the voltage correctly. I called the manufacture for help but they said this is a throw away product and no support is available. I believe that the program has been corrupted, so what I am asking is if anyone out there who might have this model charger is willing to extract the hex code and send it to me? I am a hobbyist and this become a challenge for me. I can disassemble simple code programs but this is far to complicated for me to try.
Thanks Jan
Thanks Jan
Comment