EAX61415301/8 Capacitor value needed!!!

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Moreno83
    Badcaps Legend
    • Jun 2014
    • 2008
    • The Netherlands
    #1

    EAX61415301/8 Capacitor value needed!!!

    Hey Guys ,

    Got this power supply from a 42PJ250. Its missing 2 capacitors and i would really like to know the value of those 2 so i can repair this tv.

    Capacitors i need are :

    C502 :
    C364 :

    I know that C502 is 100v.

    Is there anyone who got the same PS and can give me the values? Thanks!!!
    I only repair Panasonic plasma tv's! Currently owning a TX-P55VT50 and still searching for a ZT60!
    Tags: None
    • Khron
      Badcaps Legend
      • Sep 2006
      • 1350
      • Finland
      #2
      Re: EAX61415301/8 Capacitor value needed!!!

      In photos of this board that i've googled, C364 looks like a 6.3x11mm can. You could try tracing where its legs go, and see what voltage rating the cap "upstream" is. It doesn't really seem to be in a very "critical" location, so i kinda doubt the exact value's terribly important. 47u/50v might be a start?

      Actually, even though it's quite grainy / out-of-focus, i think i can juuuuuuuuust make out 100u/10v, from this view: http://www.bostonrecycling.net/575/l...upply-unit.jpg

      C502 looks to be 100u/100v, in this photo (you can just make out the numbers on the edge of the sleeve) - http://linhkientivi.vn/profiles/linh...8114_pj250.jpg
      Last edited by Khron; 07-05-2015, 09:38 AM.
      Khron's Cave - Electronics - Audio - Teardowns - Mods - Repairs - Projects - Music - Rants - Shenanigans

        Comment

        • Moreno83
          Badcaps Legend
          • Jun 2014
          • 2008
          • The Netherlands
          #3
          Re: EAX61415301/8 Capacitor value needed!!!

          Thanks a lot! I already googled for pictures but the last 1 is what i need!!! Thx a lot! Will give it a try
          I only repair Panasonic plasma tv's! Currently owning a TX-P55VT50 and still searching for a ZT60!

            Comment

            • Khron
              Badcaps Legend
              • Sep 2006
              • 1350
              • Finland
              #4
              Re: EAX61415301/8 Capacitor value needed!!!

              I just clicked on "Search tools", and selected Size -> Large, just to increase chances of visibility And then looked for the highest-pixel-count views i could find.
              Khron's Cave - Electronics - Audio - Teardowns - Mods - Repairs - Projects - Music - Rants - Shenanigans

                Comment

                Previous template Next

                Related Topics

                Collapse
                • veedo
                  Asus FA507R no power, capacitor needed
                  by veedo
                  Hello
                  I've got an Asus laptop which received with no power, so I found that one capacitor been damaged. I don't have schematics for that board which is DANJMMB11A0 REV:A
                  Without that caps laptop is turning on fine so problem more likely is sorted but I would like to put back the correct one as it should be.
                  If any way could help with sorting out specification somehow, I just know that my meter shows 11,2uF but is it 50V or 10V ?? or any others.
                  See attached photo off the capacitor, maybe someone have same motherboard and can check it for me please.
                  ...
                  03-24-2024, 01:16 PM
                • Prolog
                  RTX 3080 FE Identifying capacitor
                  by Prolog
                  Hi people, I hope this is the correct spot to post this, I'm new to the forum.

                  I have an RTX 3080 Founders Edition which has a burnt up capacitor (it was in parallel with another capacitor which appears damaged too), so I am hoping to be able to identify the capacitor values and order replacements.

                  I hope these photos make it clear which component I am referring to:
                  (yes, the soldering is a bit botched from removing the blown one, I know)

                  I have found the board schematic (attached), but there does not seem to be a boardview available. I have never...
                  12-01-2024, 08:27 PM
                • chth96
                  If I replace with inferior capacitor, Is it No harm to other IC components at all?
                  by chth96
                  I replaced some capacitor which is located on optical pickup pcb which is shown in the table below(PCB #2).Because it have been out of order.
                  Now,It works very well,But I just have found that all caps (6svpc100my and other part number as well) ,which is shown in the table below, has ultra-high ripple current spec.
                  It is not able to obtain any capacitor which can be a substitute for this ultra-high ripple current nichicon capacitor.
                  So I replaced it with samxon and rubycon's general capacitor(GP,YXA series).
                  I know that these capacitor will not last as long as nichicon capacitor...
                  12-22-2023, 04:34 AM
                • chth96
                  How can I test non-polarized capacitor?
                  by chth96
                  I desoldered samwha NF capacitor(50v 5.6uf) from PCB circuit of 29inch CRT TV which have symptoms of no display after I heard sound of inrush of current to TV whenever I switch on this television.
                  I measured ESR value of this non-polarized capacitor(samwha NF capacitor 50v 5.6uf) by means of MESR-100 ESR meter and It displayed 0.3 ohm

                  And When I measured its capacitance with digital multimeter and LCR-T4 Mega328 meter, It displayed 10uf from DMM and 8uf from LCR-T4 meter.
                  I found catalogue of samwha capacitor(samwha-catalogue_3.pdf file), which is attached to this thread,...
                  06-02-2024, 07:31 PM
                • supravit2000
                  Sony PS4 ADP400DR - help needed figuring out shorted pads under capacitor C 31
                  by supravit2000
                  Hi!

                  A friend of mine gave me a dead PS5 to look at. I am totally inexperienced, but when a damage is simple (i.e. failed DAP41 on PS4s, etc.), when replacing just the IC and the other very common failing parts of these consoles, problem is fixed. So I checked the voltage of the PSU - none was present. Model is ADP 400DR. I have a bunch of spare parts around, so first thing I did was to replace the IC DAP 053 (they seem quite expensive, so I put a replacement unit - TEA2016AAT. When plugged to the power outlet, 12V did come present.
                  So I reassembled the PS5 and pressed the power...
                  1 Photo
                  07-20-2024, 07:26 AM
                • Loading...
                • No more items.
                Working...