ASUS FX506L-FX706L - DABKXDMB8E0-BKXD

[naseee]

schematic

[kimsan]

Re: Asus FX506L - DABKXDMB8E0 rev.E - HELP

[emeron_302112]

Asus FX506L - DABKXDMB8E0 rev.E

hellow to all do you have a boardview for this model FX506L thankyou

[AL._.EX]

Re: Asus FX506L - DABKXDMB8E0 rev.E

Boardview

[Shamsi]

Re: ASUS FX506L-FX706L - DABKXDMB8E0-BKXD

Thank You

[230Volt]

Re: ASUS FX506L-FX706L - DABKXDMB8E0-BKXD

Hi all. Please measure the value of the resistor or tell me its marking in the schematic. In boardview this resistor is not readable

[AL._.EX]

Re: ASUS FX506L-FX706L - DABKXDMB8E0-BKXD

Hi all. Please measure the value of the resistor or tell me its marking in the schematic. In boardview this resistor is not readable

PR279- 24 kOm.

[Litwitzk26]

Re: ASUS FX506L-FX706L - DABKXDMB8E0-BKXD

Hello
Can someone please tell me where the fuse for the display lighting is located on the Asus FX506l
Thanks

[AL._.EX]

Re: ASUS FX506L-FX706L - DABKXDMB8E0-BKXD

Fuse F1

[dqtech]

Re: ASUS FX506L-FX706L - DABKXDMB8E0-BKXD

thanks sir

[jboxer]

Re: ASUS FX506L-FX706L - DABKXDMB8E0-BKXD

hi can someone tell me what can be if it isn't power consumption there? and what component is? the laptop does not power on and this is the only thing that I have found.

[zribit]

Re: ASUS FX506L-FX706L - DABKXDMB8E0-BKXD

Hello
Can someone please tell me where the fuse for the display lighting is located on the Asus FX506l
Thanks

I had a backlight problem after testing this fuse, it entered 20 V and it came out 2 V which was not normal. So I replaced it with a fuse 0603 2A 32V model 0467002.NRHF and the backlight was back.
I hope this will help you.

[Cire3PC]

Can't seem to zoom in close enough with the boardview. What capacitors are here ?

[Cire3PC]

Do the PDF Boardviews open in some special BV Viewer ? I have Flexboardview and it wont open

[deepsky5]

Re: Asus FX506L - DABKXDMB8E0 rev.E

Boardview

Hi, Do you have real boardview? .cad file or .fz

[M4n0l0307]

schematic

Thanks Friend !

[kjchatman]

can someone post a close up of the cpu voltage regulator area? i've accidentally moved a few things in that area

[jhzongjhzong87]

Can someone have the application to view the pdf file as boardview?

[Anirban75]

I have the same board from ASUS TUF F-15.
1.2v, NVVDD, VCORE , GFX seems short to the gnd. Should I consider my CPU as dead. Surprisingly why NVVDD is short also at the same time? GPU and CPU died side by side?? Any idea?

[SMDFlea]

I have the same board from ASUS TUF F-15.
1.2v, NVVDD, VCORE , GFX seems short to the gnd. Should I consider my CPU as dead. Surprisingly why NVVDD is short also at the same time? GPU and CPU died side by side?? Any idea?

Please start a new thread with your issue in the laptop troubleshooting forum ,this thread is for the schematic request only.

https://www.badcaps.net/forum/troubl...r-s-guidelines

2.2. Don't suspect that something is shorted with no reason
Shorted components are not the only failure mode of a laptop. Additionally, some places will measure low resistance to ground under normal operation. In general, high power low voltage (<2V) power rails will measure less than a few hundred ohms to ground. CPU VCore will measure a few ohms only. GPU VCore with newer NVidia GPU can even measure less than 1 ohm. It's normal. If you suspect a short to ground, always report your exact resistance to ground measurements.