Hope someone has a schematic or a boardview anything that will be agreat help to my repair of this unit .
-
-
Re: X441NC rev 2.2 schematic?
up -
Re: X441NC rev 2.2 schematic?
I found a brd but its not downloadable you need to download a software and its trials 3 days only enought to trouble shoot the laptop
http://global.wmdang.com/index/index....html?chinafixComment
-
Re: X441NC rev 2.2 schematic?
Just register and download the software then search the board numberComment
-
Re: X441NC rev 2.2 schematic?
BoardviewComment
-
Re: X441NC rev 2.2 schematic?
jejak, thank'sComment
-
Re: X441NC rev 2.2 schematic?
muchas gracias brioComment
-
PS48 is model for sub & where i suspect issue lies .
CD head unit seems to run ok , & can take a line out signal into an amp with audio present .
Can't seem to measure any voltages at secondary side of PSU within SUB unit .... -
Hey everyone,
I'm currently working on a mid-70s Sharp Electronic Digital Clock Radio, Model FY-70CH. I found the service manual online, printed it out, and have been studying it for a while. My main reasons for tackling this are: (1) I want to learn electronics and figured I'd start with something I had on hand, and (2) I want to fix its issues. Right now, the radio sounds awful, has about 5V DC at the speaker terminals, and the alarm time setting doesn't work. But I'm not asking how to fix these problems.
Instead, here's what's been bugging me so far:
The schematic... -
Ii wonder if anyone can help me. I have a Acer x163w monitor which is not powering up. The PSU main capacitor's one leg had completly come off - I replaced it but the PSU is still not outputting DC. I found the monitor in questions service manual here on manuals lib but the schematic in there is a completely different - the schematic shows no mosfet to drive the transformer while the one I have does use a mosfet - also the schematic shows only one optocoupler but mine has two.
The PSU board is labelled FM-20A02-AAA made by APD as per the image below. I am trying to find a schematic for this... -
I am Repairing this unit. It had many problems. One major one was the power transformer being about 4-5 volts low on the main B+ line which called for 66.5 Vols after the Main Filter caps but only showing about 62 Volts. Caps and the 5 amp Diode bridge were replaced which helped slightly.
The other strange problem was the small secondary winding from the PT which supplies 18 Volts AC to the "FM FLUORESCENT DISPLAY" circuit, and the small winding that supplies 8 Volts AC to the push button grain of wheat lamps. Those voltages were down from 18 Volts to 16 volts. Which was... -
I am trying to repair an LG split AC indoor unit, which does not start and gives a CH05 error code.
This indicates an error in the communication between the outdoor and the indoor unit.
The outdoor unit is fine, so the problem is the indoor PCB.
The indoor unit is an LG PC09SQ NSJ (3SNM09JA2FA), and the PCB has the following type number: EAX35907219-1.2 (see photo1)
I changed optocouplers ICO1X & ICO2X and the NPN transistor S9013 which drives optocoupler ICO2X (see photo2), but this did not remedy the fault.
Does anybody have the schematics of this board,...02-01-2025, 12:55 PM
Comment