Hello I need the diagram and the boardview of the iPad A1671, following a bad manipulation on my part I lost the backlight. Thank you
-
I tried searching the forum for whether this has been uploaded already, but couldn't find them (as a collection).
Here's a dump of a bunch of iPads, I've split into 2 archives to get under file limit
IPAD COLLECTION 1
+---iPad mini1 820-3400(A1432) 820-3243(A1454?A1455)
+---iPad mini2 820-3683(A1489) 820-3684(A1490?A1491)
+---iPad mini3 820-00008(A1599) 820-00002(A1600)
+---iPad mini4 820-00180(A1538) 820-00177(A1550)
+---iPad mini5 820-01591(A2133) 820-01495(A2124?A2125?A2126)
+---iPad Pro 12.9-4-820-01797(A2229) 820-01798(A2069?A2232?A2233)... -
Hey!
I have a iPad that doesn't start. I tried replacing the Tristar chip and I don't know if I ripped the pad or if it went with the chip but I would really like to know where that pad leads so that I can put a jumper on it.
I have the tristar chip next to the pads oriented as it should be if that helps any.
Thanks
-
Hello all Friend,
I have a mainboard iPad Air 4 for repair the customer want to change his battery but broke some component near the battery connector. Boardview exist but no schematics for component specifications.
Thanks for you help...12-13-2024, 03:05 PM -
Hi
Ive run into some issues identifying components near the Tristar chip. i have the schematic layout (no component specs)
Could someone help me identify components and specs please.
I would like to know what the bird seed is surrounding the tristar chip.
this area is bare and i need to populate this.
THanks
Simon
p.s if someone could direct me to a schematic with those components listed?10-13-2025, 04:34 PM -
Hi all,
I have a 2nd generation iPad Pro 12.9" Model number A1671. I don't usually work on these, but I suppose today is the day I start. Apologies for any ignorance on tablet matters. On Type-C to USB amp meter, showing 5v @ 1mA
(0.005W) then instantly to 0mA back and forth. Power draw is the same with and without screen and with and without battery connected. Of course, not enough current for anything to show on thermal camera.
I can't find any boardview and I'm not certain it even exists. Probing coils on top side of board reveals no voltage present...