hello.
I have vertyanov jig v3.3 but cannot find software with version 7.6 or higher. have anybody installation for it?
I have vertyanov jig v3.3 but cannot find software with version 7.6 or higher. have anybody installation for it?
-
-
Re: vertyanov jig v3.3 software needed
here. http://vssh.store/VERTYANOV_JIG/OTHE...IG_ver_3.X.rar
Password: 54321
.Last edited by SMDFlea; 12-17-2021, 06:14 AM. -
Re: vertyanov jig v3.3 software needed
thanks mateComment
-
Comment
-
Re: vertyanov jig v3.3 software needed
thanksMohammed MohanComment
-
Can someone reupload it please?Comment
-
Comment
-
Hello.
i bought this Bird rework station but comes without software for pc. I cant find anywhere to download it and dont know the name of software.
Could anyone help me pls?
/Ken... -
ABOUT ME INTRODUCTION FILE
2024 BEV, BIH, SARAJEVO START PROJECT: ELECTRIC VEHICLE TOYOTA 4 RUNNER CONVERSION http://www.bev.ba/TOYOTA4RUNNER/index.html
2023 BEV, BIH, SARAJEVO START PROJECT: SECRETS AND MANUFACTURING PLANS (AS MY REPLICA) OF THE LIBERTY ENGINE 2.0.
2022 BEV, PROJECT ?
2021 BEV, PROJECT ?
2020 BEV,BiH, Sarajevo: PROJECT IS: HOW TO SWITCH OFF PERMANENT MAGNET FIELD and HOW TO SWITCH ON PERMANENT MAGNET FIELD?
2019 BEV, Croatia, Ston:, Broce: PROJECT - PROJEKT ELEKTRIČNI GLISER http://www.bev.ba/ELEKTRICNIVANBRODSKIMOTOR/indexHR.htm...12-28-2023, 02:09 PM -
hey guyz
some one kindly help me with EZP 2023 Programmer drivers and software
thanks -
Copying DMI information from an old bios to a new one is difficult for some members, often they have no experience with a hex editor,or some that have tried find it too hard.There is an option to make things easier for those members so that they don`t need to post their own bios backup for the DMI copying.
Experienced bios modding members can help by posting in other threads the DMI offsets,macro script generated by the software and a download link to the software at softpedia mentioned in this guide,or post your macros in the comments here with a link to the bios request thread .... -
Hello everyone, I'm not really sure if this is the right place to actually post about this, but i have Aiper Scuba X1 that I'm trying to read the Microcontroller data from. The chip is National N32G455. After dismantling the unit I found a Debug connector and on the backside of the board 6 point that reads: GND RX VCC SWD TX SWC. I'm familiar with Nuvotons, MECxxx, ITE chips but NOT these kinds of microcontrollers. I need someone who can direct me to what's needed to read it ONLINE as they have coated the entire board. I got the ST-Link yesterday and connected the wires as shown in the picture...
Comment