i have an HP 840 G3 Elitebook with Bios Admin Password.
Can someone help me to remove the Admin Password? I also seen many posted a number ending with MB A01 or so. is it needed and where can i find it?
Perhaps its this from the Sticker inside: 6070B0883401 REV 1.01 A01
i have an HP 840 G3 Elitebook with Bios Admin Password.
Can someone help me to remove the Admin Password? I also seen many posted a number ending with MB A01 or so. is it needed and where can i find it?
Perhaps its this from the Sticker inside: 6070B0883401 REV 1.01 A01
I downloaded the original bios from Winbond chip and applied the fix mentioned on website: https://tickett.wordpress.com/2018/0...ssword-part-2/
After uploading the modified bin file to the laptop there was a black screen and the fan turned on, but no display.
I tried to upload the original file to the bios again, but the computer with orignal bin also did not start. What could go wrong?
I attach the original bin file read from the bios without modifications. Please be kind and remove password.
Thanks to everyone for all the wonderful job you guys are doing God bless you all, plz can anybody share a tutorial or tools for removing password in a dump file please
Thanks to everyone for all the wonderful job you guys are doing God bless you all, plz can anybody share a tutorial or tools for removing password in a dump file please
Hi
Please help me with bios dump Elitebook 840 G3 (25L12873E SOP8Pin).
I am not able to edit DMi info in bios. Please help me to edit . I tried with Wdmifit utility it shows error while press commit.
Here i am uploading 16mb clear me bin file. Please edit dmi info in it including.
feature byte and build id.
Dmi info
Sn no 5CG7041RB7
Prod ID X1U93UP#ACJ
bUILD ID 15WWCSCT601
FEAURE BYTE 3X476J6S6b727H7M7Q7W7saBA
SYTEM BOARD CT PCUZR00WD6X015
the posted bios is not ok..remove the bios chip from the motherboard before reading or writing it ..
Well, it was removed, seems got corrupt dump because of software version, just realised
Now i understand why after I read and saved dump, when I verified got error that content is different.
unfortunately cleared chip and repeogramed with other dumps from this thread, but all the time when i verify after flashing getting same error.
May it be because of programer power supply? I see in 25q128fv datasheet power 3.3v. i am using ch341a black
Comment