help with laptop dell DAJW8CMB8E1

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • marcelofct
    Senior Member
    • May 2019
    • 122
    • chile

    #1

    help with laptop dell DAJW8CMB8E1

    good morning friends I hope you can help me I have this equipment and it does not turn on, I connect the charger and I have
    the 3.3v alw but not the 5v alw check the ic pu4 (RT8223PZQW)
    I do not have the entrip1 but I do have the entrip2, I assume that this is my problem to be able to activate the mosfet pq49 and pq45 according to my appreciation

    attached schematic

    please help
    Attached Files
  • lapfix
    Badcaps Legend
    • Mar 2020
    • 2720
    • my workshop

    #2
    Re: help with laptop dell DAJW8CMB8E1

    Power sequence P 5/6 you must have this signal = ALW_ON to get +5V_ALW.so check this signal before

    Comment

    • marcelofct
      Senior Member
      • May 2019
      • 122
      • chile

      #3
      Re: help with laptop dell DAJW8CMB8E1

      Originally posted by lapfix
      Power sequence P 5/6 you must have this signal = ALW_ON to get +5V_ALW.so check this signal before
      checked ALW_ON and it is not generated by the kbc (IT8528) if it is not generated by the kbc, should I check if it has the 3.3v vcc? sorry for my little knowledge but I'm learning
      Last edited by marcelofct; 05-13-2021, 01:34 PM.

      Comment

      • marcelofct
        Senior Member
        • May 2019
        • 122
        • chile

        #4
        Re: help with laptop dell DAJW8CMB8E1

        someone with any ideas

        Comment

        • mon2
          Badcaps Legend
          • Dec 2019
          • 14148
          • Canada

          #5
          Re: help with laptop dell DAJW8CMB8E1

          As per above advice,

          1) see page 5 and follow the red circles which denote the power up sequence

          2) ALW_ON is generated by the EC - check the direction of the arrows which indicates that the EC is using an output port pin to drive the ALW_ON signal.

          3) What is the voltage reading of ALW_ON ? Place your meter in DC volts mode, then red probe on ALW_ON rail and black probe on ground.

          You can read ALW_ON @ Q32B, pin # 2.

          If this pin is not logic '1' = should be +3v3 (or close to this value) then the EC needs to be investigated.

          Confirm that the trace is not broken between the EC and Q32B, pin # 2.

          Comment

          • marcelofct
            Senior Member
            • May 2019
            • 122
            • chile

            #6
            Re: help with laptop dell DAJW8CMB8E1

            Originally posted by mon2
            As per above advice,


            What is the voltage reading of ALW_ON ? Place your meter in DC volts mode, then red probe on ALW_ON rail and black probe on ground.

            the voltage is 0v pin 83 EC

            You can read ALW_ON @ Q32B, pin # 2.

            .-on pin 2 voltage is 0.1v

            If this pin is not logic '1' = should be +3v3 (or close to this value) then the EC needs to be investigated.

            Confirm that the trace is not broken between the EC and Q32B, pin # 2.
            .-the trace is ok I measured continuity


            thank for your help , i still learning

            Comment

            • Sephir0th
              Badcaps Legend
              • Oct 2020
              • 1282
              • Germany

              #7
              Re: help with laptop dell DAJW8CMB8E1

              Resistance to ground of PQ32B Pin 2?
              FairRepair on YouTube

              Comment

              Related Topics

              Collapse

              • mikey5791
                Dell laptop model PP24L won't start from ac adapter
                by mikey5791
                Dear all,

                Bought this used Dell laptop PP24L(studio 1435) in Jan 2022. It was running smooth on 64 bit Windows 7 pro from processor Intel core Duo T6400@2Ghz with 2GB RAM. The laptop battery was charging and working fine until few months back the opening screen will display something like "replacing the battery warning", press F1 to continue. Normally i press F1, the laptop will proceed to Windows and i can use as normal.

                But last week, after i pressed F1, the laptop just shut down. I suspected the laptop battery is dead. So i pulled out the battery and...
                03-24-2023, 09:06 PM
              • Mots06
                Old Dell E5400 Laptop ( Purchased in the year 2008)
                by Mots06
                Hi, I'm unable to find the motherboard number (PPID number) or the board view for this old laptop. My laptop won't start, and when I enter the serial number on the Dell website, it says the number is invalid. The sticker on the bottom is unreadable because it has faded over time. Unfortunately, I'm unable to start the laptop to use the power cell or explore other options.I needed the CMOS Cell & it also seems the Laptop will not start now because of the power switch issue, which is yet to be detected.
                07-19-2025, 01:56 AM
              • Bowline
                Dell E6400 PT434 type Battery Charging Stuck at 1%. Battery Pinouts?
                by Bowline
                My question pertains to understanding the control circuity inside a Dell PT434 type battery used in Dell E6400, E6410 and other Dell notebooks?

                Does anyone have a circuit diagram for the inside of a Dell PT434 battery and/or a description of how the control lines work to control this battery?

                My reason for asking is I have a battery which I cannot get to charge beyond 1% in a Dell E6410 or E6400.
                The LED bar graph charge indicator on the battery shows one LED lighted when the info button is pressed.
                I have tried multiple different Dell power adapters. My Dell...
                06-11-2025, 10:13 AM
              • Calidebear
                Dell 3537 laptop doesn't boot without embedded display.
                by Calidebear
                Hi,

                I have this laptop for a long time, still it does it's job, like browsing, word , excel. Two years back laptop Hinge base broken but now it's damaging other parts of laptop so I tried to totally remove the embedded display cable from laptop and tried to boot only with external display monitor, but it doesn't boot and gives single beeps. BIOS checking the embedded display to be connected.
                So checked the schematics to bypass this issue.
                Found something but I don't know how to read this schematics.

                Dell 3537 mobo 9982p rev 3

                Schematics attached,...
                03-29-2025, 11:37 AM
              • Document Archive
                Microsoft Surface Laptop 3 13.5-inch i5/8GB/256GB SSD Laptop Platinum Notebook Specification for Upgrade or Repair
                by Document Archive
                This specification for the Microsoft Surface Laptop 3 13.5-inch i5/8GB/256GB SSD Laptop Platinum Notebook can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Surface Laptop 3 13.5-inch i5/8GB/256GB SSD Laptop Platinum boardview and Surface Laptop 3 13.5-inch i5/8GB/256GB SSD Laptop Platinum schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from...
                09-06-2024, 09:30 PM
              • Loading...
              • No more items.
              Working...