Battery pack Dell FV993 Brooks9c SJ92

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ex250
    Senior Member
    • Jun 2019
    • 97
    • Spain

    #1

    Battery pack Dell FV993 Brooks9c SJ92

    Hi, I have a dell M6600 laptop with this battery, laptop marks it as not usable and orange battery blinking in the laptop led.

    I have dismantled the battery pack and the cells seems all charged, but seems that there is no output from it in the conector.

    Any one has one schematic of it, or any idea from where to start?
    Attached Files
  • piernov
    Super Moderator
    • Jan 2016
    • 4435
    • France

    #2
    Re: Battery pack Dell FV993 Brooks9c SJ92

    Permanent failure flag most likely triggered.
    Don't mess with lithium batteries.
    OpenBoardView — https://github.com/OpenBoardView/OpenBoardView

    Comment

    • ex250
      Senior Member
      • Jun 2019
      • 97
      • Spain

      #3
      Re: Battery pack Dell FV993 Brooks9c SJ92

      I don't want to mess, but is not clear for me if the cells are all retaining 3,7v of charge, the laptop says they are unusable (but 100% charged). Makes me think about Dell wanting money for planned obsolescence.

      Comment

      Related Topics

      Collapse

      • razenxd
        How can I charge that battery pack?
        by razenxd
        Hello,
        it's not a laptop/desktop related question but I figured that someone here will have the right knowledge.
        At work we use a few Aldebaran(now Softbank/United Robotics group) Nao Robots which they use some custom 6S li-on battery packs.
        Nao robots tends to draw from the battery even if they are shut down, and the BMS tends to be a little aggresive, if the pack stays on a turned off robot for 3 months it's gonna lock and will refuse to charge.

        Now, I have noticed a few things.
        The "dead" battery, while connected to charger and NOT Charging will...
        12-05-2024, 06:11 AM
      • sam_sam_sam
        NTE Electronics “NTE5251K” Zener Diode 9.1V @ 50W Do-5.5% Want to build a 9.1 output from a 9.6 lipo4 battery pack
        by sam_sam_sam
        I have bought this Zener Diode for this project what size and wattage resistor value do I need to use to get near 50 watt output
        I bought this from an eBay seller but unfortunately they only had one

        I bought three from Vetco Electronics these are Sylvania ECG5185A 9.1@10w A to Stud what size and watt resistor do I need to use to get near 10 watt output
        I bought three of from them to also make battery packs with this output power limit in mind

        I want to use this battery pack and turn it into a 9.1 output battery pack output to eliminate using 9 volt battery...
        04-23-2025, 05:50 AM
      • Bowline
        Dell E6400 PT434 type Battery Charging Stuck at 1%. Battery Pinouts?
        by Bowline
        My question pertains to understanding the control circuity inside a Dell PT434 type battery used in Dell E6400, E6410 and other Dell notebooks?

        Does anyone have a circuit diagram for the inside of a Dell PT434 battery and/or a description of how the control lines work to control this battery?

        My reason for asking is I have a battery which I cannot get to charge beyond 1% in a Dell E6410 or E6400.
        The LED bar graph charge indicator on the battery shows one LED lighted when the info button is pressed.
        I have tried multiple different Dell power adapters. My Dell...
        06-11-2025, 10:13 AM
      • danielsak
        Dell Inspiron 3542 (Cedar_Intel-MB 13269-1) - RTC battery self-discharging and Realtek LAN issue
        by danielsak
        Hello, I have issue with Dell Inspiron 3542.

        Motherboard marking:
        Code:
        Cedar_Intel-MB 13269-1
        PWB FX3MC REV: A00
        The laptop works just fine (on battery and power supply) and doesn't cause any problems, except those described below:
        1. The first problem is that the RTC/CMOS battery self-discharges after about 2-3 weeks after installing a new battery. I have been installing different batteries (GP, Duracell, Energizer) and the problem still exist.
        1. The second problem is the LAN network card (Realtek RTL8106E), which is not detected at all in Windows. The BIOS is
        ...
        10-11-2024, 04:36 PM
      • sam_sam_sam
        Cyber Power ST625U Battery backup battery when bad so I going A123 type battery pack
        by sam_sam_sam
        I have had this battery backup for at 2 to 4 years now and the battery when bad and this is weird battery size it is the same length as a 12 volt @ 7 amp hour battery however the depth of is not the same as a 12 volt @ 5.5 amp hour battery

        I have several battery packs that are A123 batteries cell so I bought a lipo4 BMS balancing protection board for these batteries and I have a configuration that is 4S 3P these battery packs were 3S 2P so I reconfigured them but left the tabbing on one side of the battery row of battery cells and re-tabbed the other side to the configuration that...
        06-18-2023, 05:48 PM
      • Loading...
      • No more items.
      Working...