hi guys i need you help how to fix this kind of error in boardview software?
Error: ".brd" allegro is under development
Error: ".brd" allegro is under development
-
-
Re: boardview error pls help me.
Download Allegro Free Viewer from official Cadence website.OpenBoardView — https://github.com/OpenBoardView/OpenBoardView
-
MSI MEG Godlike x570 motherboard - need schematic and boardview. I have accidentally plugged in the wrong usb plug into a usb3.0 connector on front panel of PC resulting in temporarily shorting out the port. (I know it was really stupid, It was dark in my room and was rushing). I shutdown the computer and now after an immediate restart I get an overcurrent error on boot up saying my PC will shut down in 15 seconds. If I let the computer sit for about 35 minutes, I then can boot the PC without getting error. What I am hoping to find out is what parts were affected by my stupidity. Anyone have any... -
Hi all!
HISENSE 65E7KQ PRO
RSAG7.820.13512 - chassis
MT9618BAATAB - cpu
RSAG7.820.12059 - power
HD650Y3U77 - panel
KLM8G1GETF - emmc
The TV does not turn on, the standby indicator is on. All voltages are present.
Emms is dead. Not readable, not detected.
Replaced emmc.
But with another dump there is no launch
Terminal log
UART
<
AC_ON
RPMB key is not yet programmed
HASH1_VERSION=0x00000000 64bit
E-B
FDE enabled
layout pattern onebin by SAR7,0... -
Hi, I've MSI MAG B550 TOMAHAWK, which stuck on CPU error (red EZ debug LED is on).
1. I've tried to flash BIOS from USB with no success (stuck on red LED blinking).
2. No component is overheating.
Does anyone have boardview of this mobo? I would like to trace the problem, but without boardview is pretty hard task. Thanks for any help. -
Hello Sharp TV experts
Our Sharp LC-80LE642U displays one short one long flash error code which is a backlight error. I went into service mode and there were 8 lamp error counts recorded. I reset the count to 0 and did a reset. The last monitor error cause was 16 B00014639:12. 16 is the code for backlight error. I tried to power the tv up but went back into error mode.
> I checked voltages on the power supply board and they all check out .. including 3.28 volts at the error pin.
> There is power to the cpu and T-CONN and no faults found there. The cpu has a flashing...01-24-2025, 11:51 PM -
I came across a board view claiming to be the 820-00928 board, I haven't scoured through it to compare everything to the 820-00281 board view but I'm assuming they are identical and the prior is just renamed?
Either a came across a very rare version of an A1707 with the 820-00928 A board or there is an error/ erroneous assumption on the board view.
Specifically DZ3301 and 3302 are not in the same location shown on either board views, arranged differently in a position above the board view layout as shown in the attached photo.
Since these diodes are incredibly...
Comment