Received recently an MSI GL62 6QD, it had water damage in the KBC, so I replaced it and flashed the KBC firmware and BIOS from MSI site.
PWR_SW is 3.3V and does go down if I press power button.
RSMRST# is always low (0V), but if I press power button it goes to 3.3V for a while and then go back down.
A strange thing I noticed is if I connect the battery, I get a blue LED.
I'm at a loss, I've got 3.3ALW and 5ALW. And BIOS/KBC are both clean flashed. What's my next course of action?
I attached schematic for MS-16J51, but it's VERY close to the board I'm working on.
PWR_SW is 3.3V and does go down if I press power button.
RSMRST# is always low (0V), but if I press power button it goes to 3.3V for a while and then go back down.
A strange thing I noticed is if I connect the battery, I get a blue LED.
I'm at a loss, I've got 3.3ALW and 5ALW. And BIOS/KBC are both clean flashed. What's my next course of action?
I attached schematic for MS-16J51, but it's VERY close to the board I'm working on.
Comment