Hello friends, sorry for my poor English, can anybody help me for this motherboard
08274-2 jm51 dis mb 48.4cr05.021 (acer 4810t)
to uma. Thanks.
08274-2 jm51 dis mb 48.4cr05.021 (acer 4810t)
to uma. Thanks.
-
dag3bembcd0 rev d Board view and Schematic needed for Non Graphic Conversion (DIS to UMA) as the Graphic chip is bad -
Hello,
I have two almost identical computers, unfortunately both with a faulty MXM graphics card. More specifically:
- One doesn't enable the backlight and exhibits artifacts in the form of colored stripes, with the drivers crashing immediately with a BSoD upon loading.
- One was exhibiting very similar if not identical artifacts and then the GPU became fully shorted, right after a reflow attempt.
Since the LA-4982P was also manufactured without the MXM slot (pads unpopulated), I immediately thought about performing a UMA conversion. Unfortunately there...06-09-2025, 01:15 AM -
Good afternoon gentlemen, please help. how to disable Discrete To Uma Conversion ...04-21-2025, 04:29 AM -
Hey guys, need help figuring out what's causing the following issue.
I have a dell N5010 which had a bad GPU chip and a UMA conversion was performed.
Initial conversion was done per this video: https://www.youtube.com/watch?v=cq8r920tW64
After conversion, laptop boots and display comes on but once windows starts loading, it becomes all fuzzy/dotted. I initially though it could be a driver issue, so I removed the HDD and booted into BIOS settings. Image was not fuzzy but some letter jitters (like dancing dots at the edge of the letters) was visible.... -
please help friends thinkpad T470 board CT470 series NM-A931 error post "bottom cover tamper detection error"
I've already
flashed the bios clean me and updated from the Lenovo site, then removed the switch and immediately jumped the S3 from pins 1 to 4, 2 to 3 but the problem remained the same, thank you
Comment