a1278 just beep beep 820-2879

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • robertpritchard
    Senior Member
    • Dec 2016
    • 61
    • Canada
    #1

    a1278 just beep beep 820-2879

    so ive tryed all the basics ram change ect.. short to ground on c7325 and r7325
    u7300 had crouision around it so i removed all 3 still short to ground. im still getting green light fan spins and still beeps
    measurments for u7300 is 0 at every pin
    Tags: None
    • robertpritchard
      Senior Member
      • Dec 2016
      • 61
      • Canada
      #2
      Re: a1278 just beep beep 820-2879

      also no voltage on l7330

        Comment

        • robertpritchard
          Senior Member
          • Dec 2016
          • 61
          • Canada
          #3
          Re: a1278 just beep beep 820-2879

          any help would be great please

            Comment

            Previous template Next

            Related Topics

            Collapse
            • Ymotaqi
              ROG STRIX Z590-A GAMING WIFI has no POST no BEEP no diag LED
              by Ymotaqi
              The motherboard does not POST and has the following symptoms:
              When the power button is pressed, the fans and RGB turns on.
              When the power button is pressed, the motherboard voltages 12, 5, and 3 are connected.
              The motherboard does not beep.
              None of the diagnostic LEDs light up.
              USB voltage is off.
              VCORE voltage is off.
              The BIOS software was downloaded from Asus site and installed using the Q FLASH button, but it made no difference.
              I would appreciate it if anyone could guide me on the cause of the problem.
              ​
              01-12-2025, 04:15 AM
            • pcbmaniac
              MacBook A1278 (3115) No PPBUS_G3H Issue
              by pcbmaniac
              Subject: Help Needed: MacBook A1278 (3115) No PPBUS_G3H Issue

              Hello everyone,

              I'm working on a MacBook A1278 with the 3115 logic board and facing an issue with no PPBUS_G3H voltage. Here's what I've checked so far:
              1. U7000 Measurements:
                • Pin 3 has 0V, even though R7012 shows 16.5V from PPDCIN_S5_CHGR.
              2. Resistors:
                • I measured R7010 and R7011 with one leg disconnected, and both tested OK.

              Based on these findings, I believe U7000 needs to be replaced. However, I have a related question:
              • If I also decide to replace the SMC, do I need to order it pre-programmed,
              ...
              12-02-2024, 04:12 PM
            • dclass-pro
              No display a1278 820-3115-B
              by dclass-pro
              Hi guys, I have this macbook a1278 which doesn't have any image on the display, but when I turn it on I hear the chime.
              I found the L9008 choke open and reset it.
              When I turn on the macbook I have about 3v on pins 3 and 4 of the display so everything is ok but I still don't have the image.
              On the backligt pin 21 and 22 I have 0v but the fuses are all ok.
              What can I check?
              I tried another display from a macbook a1278 but from the previous year and it still doesn't work.​
              05-29-2024, 02:17 AM
            • MisterAIL
              PS5 digital / No Power / No Beep / Good power supply
              by MisterAIL
              Hi everyone,

              Brought a non functionnal PS5. Apparently only a bad PSU...
              No beep, nothing.

              After some tests i found this :
              - PSU is fine (12 volts stable)
              - 12 volts line is shorted
              - DA9065 was fried, F7003 also => Replaced both of them, short is gone on 12 volts line, no dead short anywhere else.
              - By the way, nothing change. No signal, no power, no beep.

              Mesuring all rails with my workbench psu (12 volts input)
              - 0.00 amp drawing
              - 12 volts, 5 volts, 2 volts, 1,15 volts are presents (suppose new DA9065 do is...
              3.3v PMIC
              5 Photos
              03-12-2024, 03:24 PM
            • WVUfan
              PS5 EDM-033 One Beep,No Lights, No Power Troubleshooting Help
              by WVUfan
              hello. i've a ps5 edm-033 mobo w/ no power, lights, but one beep when power pressed. i've hooked to uArt and only error code is 80871001 (DDR4 No Power or Short Circuit). i have a donor board, same model, that does power up, fan spins, blue light, and beeps 3 times, then powers off. it has a botched HDMI port replacement job. so w/ the board i'm interested in, with the error 80871001, i was able to research and obtain voltages of the SSD PMIC. i've attached pictures of the provided diagram by DylanBBK (@d62 on Discord) and my voltages and picture of my board. my question is on my picture...
              08-11-2025, 01:12 PM
            • Loading...
            • No more items.
            Working...