HP G62-b19SL , always lights up .

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • amennone
    Senior Member
    • Feb 2015
    • 63
    • italy
    #1

    HP G62-b19SL , always lights up .

    Motherboard :
    pm_a_hpc_s mv_mb_v1
    * P / N: 01013TM00-600-G

    Defect :
    By inserting the power connector without pressing the power button, the power indicator lights up and the fan runs for a few seconds, then stops, after about 20 minutes the fan continues to run at a higher speed. The power indicator always stays on. Keeping the power button pressed, the power indicator turns off and then on again, the display remains black.
    * Even without the power button (physically removed from the motherboard), the defect remains. Absorption 800 milliamps constant.
    We accept suggestions and scheme. Thank you and good job to everybody .
    Tags: None
    • caspian
      Badcaps Legend
      • Oct 2015
      • 1591
      • Laptop
      #2
      Re: HP G62-b19SL , always lights up .

      check if any IC gets hot on the mainboard.

        Comment

        Previous template Next

        Related Topics

        Collapse
        • helpmepleasethanks
          Thinkpad T440P bios repair after WIFI whitelist mod
          by helpmepleasethanks
          As per the the rules, here are the specifications of my laptop :
          • Make and model number : Thinkpad T440P
          • Serial number (S/N) : PB-03A7V7
          • Model type - Model (MTM) : 20AW-S2N800
          • Bios version : 2.50 (not 100% sure, that's what I remember)
          Here is the problem, and the events leading to it :
          1. Upgrade screen, keyboard, trackpad, RAM and CPU
          2. Reboot and use the laptop for a bit : everything is working fine
          3. Shutdown (no power) and upgrade WIFI with unsupported chip (AX210)
          4. Boot up the device : bios warning, as expected
          5. Shutdown the device again (no power)
          6. Connect the 8-pin clip of a CH341a
          ...
          01-09-2025, 12:09 PM
        • pedrolane
          LG 55EA970V OLED / black screen
          by pedrolane
          Hi

          I've found lot of help here with already answered questions, but it seems I'm in a different case.

          My LG 55EA970V OLED screen from 2013 was working well and stopped suddenly while in use, with black screen / no more audio. This model is quite unusual here in europe, so I didn't manage to find someone to help (tv shops etc).

          I've already checked the following :
          • power supply out voltage is fine at 3.5v 12v and 24v pins on the main P202 connector (picture attached)
          • when powered on by remote I can hear the relay "click",
          ...
          03-30-2023, 02:56 AM
        • Francesc V.
          Christmas lights - Something I am doing wrong
          by Francesc V.
          Hi:

          i am trying to repair this Christmas lights from my parents. They are incandescent lights, no led lights.

          I have tried with 12V a 24V small lights that I found in Aliexpress but is obvious that are not the right ones. They last microseconds connected. Do they blow because of Amps or Volts?

          If I measure the Amps in the string........it's only 90mA. If I measure the Volts in the "green box"......it's between 0 and 190V, but doing a little bit of maths from the number of bulbs in series.......it's only about 6V per lamp.

          Could...
          03-11-2023, 07:38 AM
        • Info13
          Dell H235P-00 Power Supply Failure
          by Info13
          Hi everyone,
          A H235P-00 power supply unit from a Dell Optiplex 760 PC is faulty.
          After removing it from the computer, I placed a paper clip between the green and black wires, then connected it unloaded to the mains through a series lamp.

          ➡️ First test:
          The PSU partially works: the green indicator LED lights up, and the fan starts for one second, then stops.
          A click can be heard at the moment it stops. The series lamp lights up when the power supply starts, then turns off when it shuts down.

          I then followed the advice from the forum and replaced...
          10-22-2025, 01:52 PM
        • gabrielA7
          IMAC A1418 / MB: 820-00430-a / does not turn on, Lights 3 of the 4 LEDs and turns off.
          by gabrielA7
          Does not turn on, lights 3 of the 4 LEDs and turns off and stays like this, presses the power and repeats.
          I saw that the room LED lights up only when the screen is connected, so quiet.

          We have all the power supplies, even processor, 1.8V
          One thing I found strange, it has a very low resistance in the Vcore is giving 1 Ohm , work with notes and such, I know that this is normal in some processors but with this resistance only take video card so found it strange.

          I suspect that there may be some leak in the processor.
          Anyway, when I press the power, it...
          10-29-2024, 06:48 AM
        • Loading...
        • No more items.
        Working...