Lenovo G770 won't work on battery

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • invisible4u4ever
    Member
    • Aug 2015
    • 23
    • Germany

    #1

    Lenovo G770 won't work on battery

    Hi guys...

    I need help again...

    I have one Lenovo G770 charging battery(pluged in, charging) and working on charger perfect... but when I disconnect charger laptop power off.... I looking on mainboard but I don't know where to start in finding problem... I guess some of mosfets dont switch on battery source...
    In attachment is mainboard schema...

    Please can anyone help me to find problem
    Attached Files
  • Djosla
    Badcaps Veteran
    • Dec 2012
    • 246
    • Montenegro

    #2
    Re: Lenovo G770 won't work on battery

    kb930 or kb9012 on that board ?

    Comment

    • Dumah Brazorf
      Senior Member
      • Jun 2013
      • 179
      • Italy

      #3
      Re: Lenovo G770 won't work on battery

      Page 45. Check PD101 and PQ101.

      Comment

      • invisible4u4ever
        Member
        • Aug 2015
        • 23
        • Germany

        #4
        Re: Lenovo G770 won't work on battery

        Djosla - KB930QF

        Dumah Brazorf - PD101 on one pin 18.8v on second 12v (when charger is plugged in)
        I check PQ101 when charger is plugged in I got pin1-18.8v pin2-18.8v and pin3-3v

        no voltage when charger is out

        Comment

        • Djosla
          Badcaps Veteran
          • Dec 2012
          • 246
          • Montenegro

          #5
          Re: Lenovo G770 won't work on battery

          Ok no smbus enabled charging...good thing..

          check this and post results (page 47):
          1. resistance between pins 21 and 22 of PU301
          2. resistance between pl301 and ground.
          ---than in active mode(put charger):
          3. voltage on all pins of pq303 and pq306 and pq310

          also did you check with good known battery ?
          Last edited by Djosla; 05-31-2017, 02:26 PM.

          Comment

          • invisible4u4ever
            Member
            • Aug 2015
            • 23
            • Germany

            #6
            Re: Lenovo G770 won't work on battery

            PU301 between 21 22 pin - 40ohm

            PL301 and ground 552 ohm

            PQ303 pins 1234 - 18.8v pins 5678 0.49v
            PQ306 pin1 - 18.8v pins 2,3 -0v
            PQ309 pin3 - 3v pins 1,2 - 0v

            Comment

            • invisible4u4ever
              Member
              • Aug 2015
              • 23
              • Germany

              #7
              Re: Lenovo G770 won't work on battery

              ooooo now i found new battery and when charger is pluged in ... power on... unplug charger and laptop works on battery.... but when charger is unplagged and i try to power it nothing happend... on

              Comment

              • invisible4u4ever
                Member
                • Aug 2015
                • 23
                • Germany

                #8
                Re: Lenovo G770 won't work on battery

                somebody know where is problem?

                Comment

                Related Topics

                Collapse

                • Document Archive
                  ISL6257HRZ ISL6257HRZ-T Laptop Battery Charger Datasheet
                  by Document Archive
                  ISL6257HRZ ISL6257HRZ-T Laptop Battery Charger Datasheet

                  Highly Integrated Narrow VDC Battery Charger for Notebook Computers

                  The ISL6257HRZ ISL6257HRZ-T is a highly integrated battery charger controller
                  for Li-Ion/Li-Ion polymer batteries. ISL6257 is designed for
                  Narrow VDC applications where the system power source is
                  either the battery pack or the regulated output of the charger.
                  This makes the max voltage to the system equal to the max
                  battery voltage instead of the max adapter voltage. Operating
                  at lower system voltage can improve...
                  11-05-2024, 04:43 PM
                • ferah831208
                  Strange battery present behaviour in Lenovo Legion 5-15ARH05 mb model nm-d041
                  by ferah831208
                  Hello guys, i need help with this problem, I have a NM-D041 mobo, it came with low impedance in 3v linear regulator rail, the cause was a damaged EC controller ITE8227e-192. I ordered a new one and replaced it. This laptop have a different chip for keyboard management and it8227e pins for programming ITE chips are not accesible through keyboard interface, I flashed it using i2c interface pins with vertyanov programmer because laptop was dead and SPI flash didn't have power (only 3v EC) so it couldn't access firmware stored in SPI memory. I read SPI and extracted it8227 firmware from original BIOS...
                  03-18-2025, 01:18 AM
                • pabloroggeri
                  Lenovo V310-15ISK - It doesn't work after changing the battery
                  by pabloroggeri
                  Good guys. I changed the battery to a Lenovo V310-15ISK.

                  The laptop worked perfectly, I changed the L15C4A02 battery because it didn't last very long.
                  When I connected the new battery, the charging LED stopped lighting up and the one next to the charging pin also did not react when I pressed the power button. Minutes before changing the battery it worked perfectly and stopped working after putting the new one in. Even if you put the oroginal battery in or connect it without the battery, no LED lights up when you press the power button nor does it give an image, nor does the...
                  08-23-2024, 12:01 PM
                • sam_sam_sam
                  Bauer tool battery pack charging with a HERCULES charger modification
                  by sam_sam_sam
                  The Bauer power tool battery charger just has to many issues with the charger over heating because I several HERCULES Hercules battery chargers that are 3 amp charge and because they have gone on quite a few times over the years before they came out with the fan cooling battery charger I going to modify one so I can charge Bauer battery packs faster than the crape battery charger that they have

                  Here is how this modification is going to be done I taking a 1.5 amp hour battery enclosure and gutting it removing the battery cells and replacing some Ryobi 1.5 amp hour battery pack that...
                  05-06-2023, 12:17 PM
                • sam_sam_sam
                  Milwaukee M18 HD12.0 (12 amp hour battery pack) unbalanced failure charger refusing
                  by sam_sam_sam
                  I have two Milwaukee 12 amp hours battery packs that have an issue with battery cells very unbalanced these are probably over 4 years old and been heavily used in the past but now get occasionally used heavily and when I went to use the grinder tool the battery lost battery battery power very quickly so I decided to open it up and found some battery cells voltage from 3.6 to 4.1 no wonder the battery charger was not fully charging them 3 out of 4 LEDs were on meaning that it was only 75% charged

                  So I have put them on the battery testing machine to drain each battery cell down to...
                  09-04-2022, 04:45 PM
                • Loading...
                • No more items.
                Working...