the board came with no power symptoms and found a blown cap (if I remember correctly it was PP3V3_S2_LDO line)
after cap replacement Wi-Fi is not turning on.. after few reads found "WLBT_PWR_EN" high in diode mode and not present when board is on.. thought PMU is faulty, replaced it but sadly Wi-Fi is not on as it is.. meaning this is a bad Wi-Fi chip.. and since Wi-Fi chip is paired to the M2 SoC changing the chip is meaningless..
all wifi chip vcc lines are on = 3v3 aon wlbt, 1.8v s2 and 1.25v s2
Is there other workaround for this issue?
after cap replacement Wi-Fi is not turning on.. after few reads found "WLBT_PWR_EN" high in diode mode and not present when board is on.. thought PMU is faulty, replaced it but sadly Wi-Fi is not on as it is.. meaning this is a bad Wi-Fi chip.. and since Wi-Fi chip is paired to the M2 SoC changing the chip is meaningless..
all wifi chip vcc lines are on = 3v3 aon wlbt, 1.8v s2 and 1.25v s2
Is there other workaround for this issue?
Comment