[help]asus gl703ge dead, no shorts!

[phantomEVO]

Re: [help]asus gl703ge dead, no shorts!

PU12 pin 6 2,2kohm
PU13 pin 10 54ohm

[phantomEVO]

Re: [help]asus gl703ge dead, no shorts!

i don't understand where should be the problem...i have no shorts anymore...

[phantomEVO]

Re: [help]asus gl703ge dead, no shorts!

sorry if i insist..i know i'm an idiot....

i've tried to use my power bench supply...

here's the result

https://files.fm/u/zdpyhhykv

and this is with thermal camera

https://files.fm/u/7xjxemry8

[mon2]

Re: [help]asus gl703ge dead, no shorts!

The current draw is very low.

Confirm that your ACDRV is ~25v to enable the DCin mosfets and that the 20v is not from the internal diode of the 2nd DCin mosfet.

[huzo]

I have the same board, dead as a door knob, i get 20V on the Board,but no 3.3V or 5V, on the PU9 which is RT6575DGQW i have some voltages comming out of the chip, 2.4V and 4.5V,dunno what pins exactly, it was late and i did a quick measeurement, but not getting the correct outputs probably, no shorts anywehre on the board, so if i change the RT6575DGQW i am good to go?