Hello all, help please id manufacturer and code for part labeled FK=8A. Part is located near the VRM at the bottom assuming some kind of 5 volt controller. Motherboard has shorted 5 volts and this is possibly the culprit along with a 10 ohm resistor nearby 
. Motherboard is MSI MPG Z490 Gaming Carbon wifi. Thank you!😊
-
MSI MPG Z490 GAMING EDGE WIFI (MS7C79) Motherboard Boardview
MS-7C79... -
Looking for someone who would be kind enough to share a known working BIOS dump from this motherboard model. Currently have one and 90% of the BIOS is empty data -
I am currently working on a MSI X470 Gaming Pro Carbon that has a weird issue: The board is working fine on startup, but after the BIOS initializes, the board shows "USB overcurrent detected" on the screen and shuts down after 15 seconds. The issue is only happening when the system is ready to boot.
What I have tried so far:
-optical inspection: no damages whatsoever
-BIOS update: The BIOS was updated to the latest stable version (I) using the CH341 1V8
-PM_OC: I checked every double mosfet (7002N) that is connected to that line. All the PM_OC-signals are...09-02-2025, 10:40 AM -
Does anyone have a boardview or schematic file for an Asus TUF Gaming X570-Plus(wifi) R1.05? I have the boardview file for the R1.04 version of the motherboard, but it's different in the area where my R1.05 board appears to have had a component broken off. -
Looking for ASUS TUF Z390-PLUS GAMING (WiFi) BIOS dump — rev 1.06, full 16MB SPI image with EC, I recieved a board without spi chip. I extracted and clean me using FIT on all asus provided cap and all are not working. please help
Comment