Announcement

Collapse
No announcement yet.

Intel d850mv mystery cap

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Intel d850mv mystery cap

    I decided to replace the caps in an old motherboard for fun. The main blown capacitor, however, appears unlabeled except for the top, where the bulge has made it mostly unreadable. What you can see, especially after scraping off the residue, is:
    "HD K3
    1x00
    10V"
    The x in "1x00" is an unreadable digit, and searches for HD K3 have turned up nothing useful. I'm guessing it is either 1000uF or 1500uF? The diameter is 10mm.

    Anyone have any insight into what uF this might be? Oh and pardon the dust, these pictures were taken just after it was removed from the closet and before it was dusted off. =)

    Thanks!
    Attached Files
    Tags: None
    #2
    Re: Intel d850mv mystery cap

    It could possibly, but not necessarily, be the same value as the caps next to it.

    http://www.intel.com/design/motherbd/mv/mv_photo.htm


    If Intel ran out of caps from one supplier they might substitute caps from another.
    .

    Comment

      #3
      Re: Intel d850mv mystery cap

      It's a Nichicon HD series - I recognize both the logo and the series designation. You migh check Nichicon's catalog online to see what is offered in that part's case size and in the HD series. If it is in parallel with other identical parts, use the same series or an equivalent series from another vendor (UCC KZE or Rubycon ZL).
      PeteS in CA

      Power Supplies should be boring: No loud noises, no bright flashes, and no bad smells.
      ****************************
      To kill personal responsibility, initiative or success, punish it by taxing it. To encourage irresponsibility, improvidence, dependence and failure, reward it by subsidizing it.
      ****************************

      Comment

        #4
        Re: Intel d850mv mystery cap

        Thank you both!

        After browsing Nichicon's catalog for the HD series I found only one item with the same diameter and length with 10V and it shows it as 1500uF. Also, the caps next to the Nichicon are Sanyo 6.3V 1500uF, so I think 1500 is the best bet.

        Thanks again!

        Comment

          #5
          Re: Intel d850mv mystery cap

          A Nichicon HD failure, and it's near the PSU ATX connectors, not the VRM output. Definitely a busted PSU feeding that 850 mobo, probably overvoltage on +5v and/or +5Vsb.

          Comment

            #6
            Re: Intel d850mv mystery cap

            Aren't those "solid caps" suppose to be "unbreakable"?

            Comment

              #7
              Re: Intel d850mv mystery cap

              its not a solid cap
              capacitor lab yachtmati techmati

              Comment

                #8
                Re: Intel d850mv mystery cap

                Yup, it's just a regular Nichicon HD Aqueous Aluminium Electrolytic, but supposed to be better for the environment because they've eliminated the outer black plastic sleeve and used a transparent lacquer finish on bare aluminium instead. The values are printed on top for better visibility.

                Comment

                  #9
                  Re: Intel d850mv mystery cap

                  Originally posted by linuxguru
                  Yup, it's just a regular Nichicon HD Aqueous Aluminium Electrolytic, but supposed to be better for the environment because they've eliminated the outer black plastic sleeve and used a transparent lacquer finish on bare aluminium instead. The values are printed on top for better visibility.
                  How can you tell the difference?

                  Comment

                    #10
                    Re: Intel d850mv mystery cap

                    Polymer ("solid") caps also fail, e.g. the Fujitsu polymer types mentioned in several threads here.
                    PeteS in CA

                    Power Supplies should be boring: No loud noises, no bright flashes, and no bad smells.
                    ****************************
                    To kill personal responsibility, initiative or success, punish it by taxing it. To encourage irresponsibility, improvidence, dependence and failure, reward it by subsidizing it.
                    ****************************

                    Comment

                      #11
                      Re: Intel d850mv mystery cap

                      Redshift: The only visible difference between an Aluminium Electrolytic in a bare-metal can and a Solid Polymer-Aluminium in a bare-metal can is that the former will have vent lines scored on the top, while the latter may not - but this may not be a distinguishing feature for the smaller values (<470 uF), which may not have score lines for either type.

                      The other characteristic is that SPAs are typically found in lower values on a motherboard - say 560/4v .. 820/4v. Electrolytics in motherboard use in the VRM sections typically start at a minimum of 1000/6.3v and go as high as 4700/6.3.

                      Other than that, there's no easy way to tell the difference except by referencing the series (from the information printed on the can) in the manufacturers catalogues. It just happens that the Nichicon HD is a very widely used series, having been used in Intel motherboards for a long time, and is thus easy to recognize. It comes in an older version with a black plastic sleeve and white lettering on the side, and a newer lacquer on bare-metal version with black lettering on top.

                      Comment

                        #12
                        Re: Intel d850mv mystery cap

                        It comes in an older version with a black plastic sleeve and white lettering on the side, and a newer lacquer on bare-metal version with black lettering on top.
                        I don't think age is a determining factor on the sleeve/coating. I have on hand samples of 560uF, 50V HDs that have a black plastic sleeve, D/C = H0644. IOW, manufactured in early November of 2006.
                        PeteS in CA

                        Power Supplies should be boring: No loud noises, no bright flashes, and no bad smells.
                        ****************************
                        To kill personal responsibility, initiative or success, punish it by taxing it. To encourage irresponsibility, improvidence, dependence and failure, reward it by subsidizing it.
                        ****************************

                        Comment

                          #13
                          Re: Intel d850mv mystery cap

                          PeteS: You're correct - I should have stated that the lacquered HD was introduced later, but both types continue to be manufactured and sold today.

                          Comment

                            #14
                            Re: Intel d850mv mystery cap

                            The thing I'm wondering about is whether the coating reduces the cap's ability to dissipate heat as compared to the standard sleeving (BTW, with RoHS, sleeving was changed from PVC to polyester).
                            PeteS in CA

                            Power Supplies should be boring: No loud noises, no bright flashes, and no bad smells.
                            ****************************
                            To kill personal responsibility, initiative or success, punish it by taxing it. To encourage irresponsibility, improvidence, dependence and failure, reward it by subsidizing it.
                            ****************************

                            Comment

                            Previous template Next
                            Working...
                            X