3090 FE Part Confirm/Identification

[H H]

Hello,

I'm hoping someone could help me confirm if I have identified the following parts correctly.

Apparently the DP cable became stuck inside the graphics card and was yanked out. This caused some sort of short which burned the DP contacts and blew some resistors and ferrite beads.

The parts needing replacement are on the back of the board behind the HDMI input.

I have identified the parts as the following:

C6037: MLCC 0.1uf/16v(0402)x7R W05

R6016: RES 499 OHM 1/16W (0402) 1%

LB10911: Ferrite Bead (0402) 600HM.500 MA

I identified the parts by comparing the boardview of other boards and looking at the posted schematic diagrams for the FE. Unfortunately, there does not seem to be a boardview of the FE.

I'm wondering the order of the parts, on some boardview the parts are listed in order of

Ferrite Bead / RES / MLCC

or

RES / Ferrit Bead / MLCC

By reviewing the schematics for the RTX 3090 Founders Edition, I have come the conclusion that the correct order is:

RES / Ferrite Bead / MLCC

Would anyone be able to confirm/ check my work?

Photos are attached.

Thank you in advance