Greetings. I have a sceptre x220t naga that I just replaced all the caps in the power supply. Before it did nothing with only flashing power light. The four capxon 470 25v were obviously bad, but I replaced them all. From Digi-key they are: four P12389-ND's, two P12366-ND's, and one 493-1575-ND.
It does power on now and I do get a 'no signal' message, BUT it only lasts for a couple seconds then goes off and the power light goes back to blinking.
It does power on now and I do get a 'no signal' message, BUT it only lasts for a couple seconds then goes off and the power light goes back to blinking.
But today, I’m making an exception here. Why? No idea. Perhaps only because the repair details are still “fresh” in my head… which is ironic, given this is a 16 year old monitor that hardly anyone will care about today. It is new to me, though. 
I picked it up last November from someone on my local Craigslist. It wasn’t very close to where I live, but was close to a family friend that I had to go visit anyways. So after watching the posting on Craigslist for a few weeks and seeing it getting...
Comment