Announcement

Collapse
No announcement yet.

Sony SDM-HS75P

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #41
    Re: Sony SDM-HS75P

    I had the problem of my Sony SDM HS75P switching oiff & on,then blinking every minutes,& then totally stopped working.No response of power button.

    I opened & checked the power supply - it was ok 4.95V & 12.17 V.
    On further inspection I found U202 defective,which is located just above the crystal,
    on the display driver module,right side of graphic processor.

    Removed the part & installed 470 ohms resistor & 3V zener in series across gnd & 5V.
    the junction of resistor & Zener diode 3V connected to the output. Now it is working fine.The pictures are attached.Any clarification,please write here.

    Comment


      #42
      Re: Sony SDM-HS75P

      Hope this will help you in rectifying the problems of those owners of Sony SDM HS75P.
      I had the problem of my Sony SDM HS75P switching oiff & on-10min-5min-1 min,then blinking every minutes,& then totally stopped working.No response of power button.

      I opened & checked the power supply - it was ok 4.95V & 12.17 V.
      On further inspection I found U202 defective,which is located just above the crystal,
      on the display driver module,right side of graphic processor.

      Removed the part & installed 470 ohms resistor & 3V zener in series across gnd & 5V.
      the junction of resistor & Zener diode 3V connected to the output. Now it is working fine.The pictures are attached.Any clarification,please write here.

      Comment


        #43
        Re: Sony SDM-HS75P

        Can you put a picture to see what u did

        Comment

        Working...
        X