Hi
I'm in the early stages of trying to build myself a rework station so I would like to keep things as simple as possible and also within reason cost wise.
Whilst doing some research on what others had done i came across a design that had been done in fritzing which i have attached. The person who designed this seems to have abandoned it as I am unable to contact him.
I couldn't get on well using fritzing so i have created a schematic from the fritzing layout.
There's quite a few component values that I'm not sure about, but for now if you guys can cast your expert opinion on whether I've draw the schematic correctly that would a great help.
I'm in the early stages of trying to build myself a rework station so I would like to keep things as simple as possible and also within reason cost wise.
Whilst doing some research on what others had done i came across a design that had been done in fritzing which i have attached. The person who designed this seems to have abandoned it as I am unable to contact him.
I couldn't get on well using fritzing so i have created a schematic from the fritzing layout.
There's quite a few component values that I'm not sure about, but for now if you guys can cast your expert opinion on whether I've draw the schematic correctly that would a great help.
Comment