Re: Samsung UN60FH6200F TV - No backlight - Please help
Good news - I figured it out! There were three resistors blown on the back side of the board, near where the LEDs plug in. They were, from the shopjimmy picture, supposed to be 3R00 resistors, in parallel, and I'm guessing they were just acting as a fuse. I measured one at 16Mohm after desoldering it, and guessing that that was the problem, shoved a beefy 1.5ohm resistor in their place. Worked like a charm.
(Note that I will not mention the brief moment there was a 47 ohm resistor there to see if it worked... and the blue smoke it released).
Good news - I figured it out! There were three resistors blown on the back side of the board, near where the LEDs plug in. They were, from the shopjimmy picture, supposed to be 3R00 resistors, in parallel, and I'm guessing they were just acting as a fuse. I measured one at 16Mohm after desoldering it, and guessing that that was the problem, shoved a beefy 1.5ohm resistor in their place. Worked like a charm.
(Note that I will not mention the brief moment there was a 47 ohm resistor there to see if it worked... and the blue smoke it released).
Comment