Hello guys! I got a Korg Vocal Sampel here that doesn't get powered on.
I use it with six 1.5V Batteries (as stated on the back of the case).
Pressing the power button does absolutely nothing.
Visually I can not see anything wrong with the PCB.
The two soldering points where the PCB gets its power get 9.75V.
The power button seems to work, since on continuity mode it beeps when I press it.
I found out that the circled resistor (1M?) has 9V on the one side, and after the resistor there is no volage. No matter if I press the button or not.
Could this be the reason the thing is not powering up?
Picture here: https://imgur.com/a/FZTSx1i
EDIT: It seems to be a fuse and not a resistor. There is a writing beside it saying FU1. The SMD as a M on it
I use it with six 1.5V Batteries (as stated on the back of the case).
Pressing the power button does absolutely nothing.
Visually I can not see anything wrong with the PCB.
The two soldering points where the PCB gets its power get 9.75V.
The power button seems to work, since on continuity mode it beeps when I press it.
I found out that the circled resistor (1M?) has 9V on the one side, and after the resistor there is no volage. No matter if I press the button or not.
Could this be the reason the thing is not powering up?
Picture here: https://imgur.com/a/FZTSx1i
EDIT: It seems to be a fuse and not a resistor. There is a writing beside it saying FU1. The SMD as a M on it
Comment