Hello! After reading all about it here, I replaced the infamous 2 Bad Caps in my Emu 1820m soundcard, which was working okay before the cap replacement. Now it does not show ANY power signs at all. Could the new caps be the wrong kind, bad or is it my crappy ugly soldering?
I replaced the exact two caps everyone else does with success. As seen in the picture here:
http://productionforums.com/viewtopic.php?t=13240
They WERE BULGING, but still working, with static. The bad caps I pulled were G-Luxon, 10Vdc 680uF, 105c, LZ. To replace them, I installed Nichicon -- 1000UF 1000mfd 25V Electrolytic Capacitor 105c.
http://www.ebay.com/itm/271408068601...%3AMEBIDX%3AIT
Shouldn't they work in theory? I followed ALL the advice. Everyone says it's okay to up the UF a little and volts a little, but not over 25v. Before I yank and jiggle and pray, any advice is GREATLY appreciated! Thank you very much!
I replaced the exact two caps everyone else does with success. As seen in the picture here:
http://productionforums.com/viewtopic.php?t=13240
They WERE BULGING, but still working, with static. The bad caps I pulled were G-Luxon, 10Vdc 680uF, 105c, LZ. To replace them, I installed Nichicon -- 1000UF 1000mfd 25V Electrolytic Capacitor 105c.
http://www.ebay.com/itm/271408068601...%3AMEBIDX%3AIT
Shouldn't they work in theory? I followed ALL the advice. Everyone says it's okay to up the UF a little and volts a little, but not over 25v. Before I yank and jiggle and pray, any advice is GREATLY appreciated! Thank you very much!
Comment