Hi, I am new here.
In my endeavor to resurrect my monitor, I resurrected this old post https://www.badcaps.net/forum/showthread.php?t=7662.
My Acer monitor gone black the other day, the green power was on but the monitor was black, no Acer logo came on when I power it up.
After some research, I ordered a repair kit replaced all caps.
Disappointed, it seems the problem goes deeper then just a few bad caps but it show a very slight improvement if I may call that. Now when I plug in a video source, it show a very faint image for a very short time (less then 5 seconds) then it goes black.
My question is, This monitor has the exact same DAC-19M009 power supply, I have replaced all caps except the big one near the power cable plug. But the repair kit came with a matching pair MOSFET labelled 40T03GP for which I have no idea where to put them.(this is where I got confused, the original pair has very hard to read label and from the little I could read, I know for sure they do not match.) Am I suppose to replace the two similar looking pair on the heat sink with the new pair?
Oh, the fuse is not blown, forgot to mention.
Thanks in advance.
In my endeavor to resurrect my monitor, I resurrected this old post https://www.badcaps.net/forum/showthread.php?t=7662.
My Acer monitor gone black the other day, the green power was on but the monitor was black, no Acer logo came on when I power it up.
After some research, I ordered a repair kit replaced all caps.
Disappointed, it seems the problem goes deeper then just a few bad caps but it show a very slight improvement if I may call that. Now when I plug in a video source, it show a very faint image for a very short time (less then 5 seconds) then it goes black.
My question is, This monitor has the exact same DAC-19M009 power supply, I have replaced all caps except the big one near the power cable plug. But the repair kit came with a matching pair MOSFET labelled 40T03GP for which I have no idea where to put them.(this is where I got confused, the original pair has very hard to read label and from the little I could read, I know for sure they do not match.) Am I suppose to replace the two similar looking pair on the heat sink with the new pair?

Oh, the fuse is not blown, forgot to mention.
Thanks in advance.
Comment