newbee capacitor samxon 150uf 450v

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • jimbob8467
    New Member
    • Jan 2014
    • 9
    • England
    #1

    newbee capacitor samxon 150uf 450v

    I am a newbee on here so if i am not supposed to be here then forgive me.cap 150uf 450v out of a 42inch lcd Toshiba TV all caps look good tests well i am a bit puzzled, this one gives me a reading of 137uf on the meter, the tv switches on ok then about a minute it will go off and 30 secs later will switch itself back on. The question..... is this cap ok or should it be replaced as i have read that as long as its within a 10% range it should be ok tested with newcason XC6013L setting on 200uf thanks. jimmy
    Tags: None
    • jimbob8467
      New Member
      • Jan 2014
      • 9
      • England
      #2
      Re: newbee capacitor samxon 150uf 450v

      might answer my own question here did not see the HP(M) on the cap believe giving it 20% is this correct????
      Last edited by jimbob8467; 01-21-2014, 05:19 PM.

        Comment

        • Sparkey55
          Badcaps Legend
          • Jan 2010
          • 1523
          • USA
          #3
          Re: newbee capacitor samxon 150uf 450v

          Originally posted by jimbob8467
          might answer my own question here did not see the HP(M) on the cap believe giving it 20% is this correct????
          Usually -10% to +20% tolerance. 137uf sounds right to me.

            Comment

            • jimbob8467
              New Member
              • Jan 2014
              • 9
              • England
              #4
              Re: newbee capacitor samxon 150uf 450v

              thankyou for your reply

                Comment

                Previous template Next

                Related Topics

                Collapse
                • Prolog
                  RTX 3080 FE Identifying capacitor
                  by Prolog
                  Hi people, I hope this is the correct spot to post this, I'm new to the forum.

                  I have an RTX 3080 Founders Edition which has a burnt up capacitor (it was in parallel with another capacitor which appears damaged too), so I am hoping to be able to identify the capacitor values and order replacements.

                  I hope these photos make it clear which component I am referring to:
                  (yes, the soldering is a bit botched from removing the blown one, I know)

                  I have found the board schematic (attached), but there does not seem to be a boardview available. I have never...
                  12-01-2024, 08:27 PM
                • chth96
                  How can I test non-polarized capacitor?
                  by chth96
                  I desoldered samwha NF capacitor(50v 5.6uf) from PCB circuit of 29inch CRT TV which have symptoms of no display after I heard sound of inrush of current to TV whenever I switch on this television.
                  I measured ESR value of this non-polarized capacitor(samwha NF capacitor 50v 5.6uf) by means of MESR-100 ESR meter and It displayed 0.3 ohm

                  And When I measured its capacitance with digital multimeter and LCR-T4 Mega328 meter, It displayed 10uf from DMM and 8uf from LCR-T4 meter.
                  I found catalogue of samwha capacitor(samwha-catalogue_3.pdf file), which is attached to this thread,...
                  06-02-2024, 07:31 PM
                • chth96
                  Is it no harm to replace with capacitor without ripple current rating?
                  by chth96
                  When I tried to repair LG 29 inch CRT TV, I found that the ESR value of samyoung SMS capacitor(160v 2.2uf), which is very close to D1879 transistor, is 6 ohm.


                  Judging from above ESR Meter Table,I think It is necessary to replace this sms capacitor.So I visited local electronics shop,and I purchased 160v 2.2uf rubycon YK capacitor.
                  But when I browse through rubycon YK datasheet,I found that there is no ripple current rating for 160v 2.2uf specification. But On the contrary, I found 39 mA ripple current rating for 160v 2.2uf SMS capacitor.
                  Rubycon YK DataSheet (b...
                  04-19-2024, 05:19 AM
                • chth96
                  Should I replace polymer capacitor?
                  by chth96
                  a few days ago I finally purchased mser-100 v2 and I tested its abillity of measuring ESR value.
                  I found that It shows pretty accurate ESR value for electrolytic capacitor,But When I measure polymer capacitor of dreamcast game console,I found that one third of polymer capacitor's ESR value is more than twice the value of ESR meter table.(for example, I measured one polymer capacitor of 6.3v 100uf, It showed ESR value of 7.68)
                  Although my dreamcast now turns 20 years old but it still works. I occasionally have played game with it.
                  Is this ESR value of polymer capacitor correct?...
                  11-18-2022, 04:22 AM
                • GEARELECTRONICS
                  Samxon capacitor esr
                  by GEARELECTRONICS
                  Hi all,
                  I need your advice.
                  -SAMXON 2200uf 50V tested 0.00 esr on Dick Smith Blue Esr meter and 2027 ohm on FLUKE 179 multimeter.
                  -Is this esr reading realistic?
                  Thank you
                  05-29-2023, 07:26 AM
                • Loading...
                • No more items.
                Working...