1000uf 120v 46mmx18mm or something close, Thanks
Looking for a Cap 1000uf 120v 46mmx18mm or something close
Collapse
X
Related Topics
Collapse
-
by qsencHello everyone,
Anyone with a Dell 7330 LA-581P can take a close photo of the bios section as i only have board view ( no available schematic ) and i need to search for the correct values. Please see attachments...02-28-2025, 12:45 PM -
by sam_sam_samIf I remember correctly this indicates a battery failure the other day I had to turn off the power going down the driveway to do something and forgot to turn it back on and the battery went dead but it charged back up and I thought everything was okay but apparently not because now it refuses to close and the battery power light and the line power light goes off when you give it a request to do something I have had so many devices that the battery have gone bad I am sick of it...
-
by sam_sam_samHere is the page of capacitors that I can choose from what is a good choice for a FSP 400-60GLC
https://www.digikey.com/en/products/...Xmc1YPJ6BlESoA
I try to use a 565-1664-ND which is a 10mm in diameter unfortunately it will not fit because there are two of them the same size and value and there is no room and they go to two different circuits not in parallel...-
Channel: General Capacitor Questions & Issues
-
-
by corrizeHello, I will have to solder a very small FPC connector (pins : 0.3mm), on the pcb of CMOS sensor, it is very close. I was surprised by movie on ytb, someone soldering directly with hot air directly on the sensor without kapton, nothing.
CMOS sensor seems resist to high temps.
But I also directly saw sensor broken because a blocked motor at the corner became very hot and probably bent the metal frame and cracked the sensor.
I have low melting point solder.
I will probably test hot air directly on one of plastic connector (I have a lot) at 320 degree on a test... -
by frannyjunkHi, my Vizio M60-C3 does not power on. No lights whatsoever. Upon opening up the TV, the power supply board has 4 bulging capacitors. Each is 1000uF 16V. I have read that one can use capacitors of the same uF and higher voltage rating, but is 1000uF 35V capacitor too high of a voltage rating? My local shop only has these higher voltage capacitors so would rather just buy the 35V variety if it is OK to use them.
Any thoughts if OK to use these higher voltage capacitors? - Loading...
- No more items.
Comment