Samsung 225BW Monitor Caps

[primoadamp]

I need to replace two bad caps in my monitor.
The two bad caps are the same: 820uF, 25 volts, 10x20mm, radial

There are multiple caps I found on mouser.com but which ones do I need?
Low ESR? High Frequency?

I found this one. Could this be it?
http://www.mouser.com/ProductDetail/...2%252baxzw0%3d

[japlytic]

Re: Samsung 225BW Monitor Caps

Welcome, primoadamp!

You are correct about these capacitors needing to be low-ESR (low-ESR usually means they are high frequency units) such as Nippon Chemi-Con KY (or KZM if you can get them) or equivalent.

[primoadamp]

Re: Samsung 225BW Monitor Caps

Welcome, primoadamp!

You are correct about these capacitors needing to be low-ESR (low-ESR usually means they are high frequency units) such as Nippon Chemi-Con KY (or KZM if you can get them) or equivalent.

So the low esr caps are the ones I need for this monitor?

[ipman]

Re: Samsung 225BW Monitor Caps

I suppose the original ones were Capxon.
I exchanged similar ones with 1000 microfarad ones made by Sancon which, while not being Low-ESR, had lower ESR value than the original Low-ESR Capxons. Works fine anyway, because they are just filtering caps.
Pay atention to temperature rating, they must be rated at 105 degrees celsius because they are quite close to a double-diode heatsink.