Anyone familiar with what this part# may be complete? Its on a Miller Spectrum 375 plasma cutter board, Q6 is the location on the board.
-
Does anyone familiar with what this full part# is? Its off the mainboard from a Miller Spectrum 375 plasma cutter, component location Q6. Thanks for any help guys! -
Hmm… someone brought me this Miller Diversion 165 TIG welder for repair. Claim is it doesn’t arc. Well it tries doing something if I put the tungsten tip straight to the aluminum plate. All I hear is a little tick… tick… tick…, I have the power LED on, but the other (blue?) LED doesn’t light up. I think it is supposed to when there is an actual arc.
So I opened it up, found a bad looking connector between the main board and the small HF board. Checked the SCR and few other things on it and found nothing. Then tried again. Same thing. I will not for its own life strike... -
Can someone please direct me to the location of the BIOS? I've attached an image of the motherboard. Would like someone to point out the location or if I do indeed need to pull the motherboard if it's on the other side. Thank you.... -
pls help guys..This laptop powers up but nothing on screen..have tried different ram ..it may be the bios? can someone point out the location of the chip pls.?... -
Hello everybody,
I'm looking for a boardview and/or schematics for
Device: Plotter Cutter motherboard
Brand: GCC
Model: GCC Expert II 24 XL
Thanks in advance!...07-02-2025, 04:29 PM