schematic and boardview CRESCENT 6050A3022501-MB-A01 HP_EliteBook_840_G6
-
boardview CRESCENT 6050A3022501-MB-A01 and schematic HP_EliteBook_840_G6 6050A3022501-MB-A01
...11-12-2024, 08:35 AM -
Hello everyone,
I am looking for the schematic and/or boardview files for the following motherboard:
Model: DAG37KMBAC0
Revision: Rev C
Laptop: HP Pavilion 17-ab302nq
If anyone has the boardview (.brd / .bvr) or schematic (.pdf), I would be very grateful if you could share it.
The board is currently under repair (no power / power issue), and any documentation would help a lot.
Thank you in advance!
Best regards.12-06-2025, 01:27 PM -
Hi everyone,
I’m working on repairing a Lenovo Legion Go that suffered liquid damage. Unfortunately, one of the ICs on the motherboard burned out, and I haven’t been able to find any boardview or schematic for this model anywhere.
Does anyone happen to know what this particular chip is, or have access to the schematic/boardview for this motherboard? Any help or reference would be greatly appreciated. -
Hello,
I am in search of a schematic or boardview for Lenovo Ideapad Flex 5 14ALC7.
No power and no charging LED with AC Adapter connected. AC Adapter is functioning at 19V, and also tried another Lenovo AC Adapter -- no charging LED still.
There is an active 19V from the USB-C port to the motherboard with AC Adapter connected, so the port is also fine. I am assuming there is a short on one of the power rails, but don't know where to start looking.
Any insight, schematic or boardview would be greatly appreciated.
Model: Lenovo Ideapad Flex 5 14ALC7... -
hello firends
i search the schematic or boardview
I have this motherboard, but I can't find the schematic or the boardview.
The problem is that on the chip marked where 3V should be, there are 5 volts, which indicates that the two are connected.
So the computer doesn't turn on, and the 3V disappears after a few seconds.
The original problem was that when I turned off the computer, the fan stayed on and saw that it was bad since it was directly in the 5V area.
The new problem arose after removing the bad chip.
3V and 5V remained together,...08-19-2025, 08:25 PM
Comment