Yes i look same, its after charging connector mosfet. Thanks you R_J
Tomorrow jeffer dacon i give you the name of mainboard
-
First post -Intel NUC 10i5 -BXNUC10i5FNH not powering on -IC burnt- request for IC details/datasheetHi all,
I came across this very active forum with knowledgeable folks on electronic circuits and components, while google searching for the details of my burnt IC marked 7603 in Intel NUC board. I joined this forum today and this is my first post here.
I recently got an Intel NUC 10i5 and had installed Linux Mint and was using it for about a month when it died suddenly and did not power up after that.(Power Adaptor is ok). When I opened the NUC , there was a burnt IC marked 7603 (and ILCB in second line). I am unable to find the details/datasheet of this IC. I will be grateful if... -
Hello, I have a faulty screen with an I8996c chip getting very hot, I would like to know what this chip is doing, so I request datasheet as I did not find anything online. Or schematic for NCPD-TS156-014 V1.0 board (screen model is LM156LFCL) would be also very helpful. Thank you in advance
-
Hello everyone, i would like to request your help to identify one IC.
It has only labled:
85XT
SAYA
I want to know if theres a datasheet of it or there's any compatible model of ic part that could replace him and fit.
Thanks in advance... -
Hi all.
Anyone have or can share the datasheet for SKhynix H5GQ8H24MJR-R4C GDDR.
Thanks -
Trying to learn electronics repair as a hobby. I have no formal training in electronics, circuits, etc. Everything I know, which isn't much, has been learned from watching youtube videos, reading books, forums, etc. This means, sometimes I have a hard time understanding and interpreting what's important when I look at datasheets, and such.
My brother has a TV that I'm working on now. He said he was watching it, he heard a loud pop and it went off. I used my DMM to check the fuse, it was blown. From watching lots of hours of electronics repairs on youtube, I figured that was just a...07-07-2025, 07:38 PM
Leave a comment: