TV will turn on fine, but there is no picture and the backlights flicker constantly. If I unplug the LVDS between he T-Con and main board, the backlights stop flickering (there just is of course no picture). I really thought it was the T-Con, so I sent it off to be repaired. The guy who repaired it said he tested it on a model in his shop and it worked. However, I'm having the same issue before and after the 'repair'.
These are my voltages with the T-Con unplugged from the main board:
1: B13V...12.6
2: PWM_DIM...2.9
3: B13V...12.6
4: B13V...12.6
5: Vamp...12.6
6: BLU_ON/OFF...4.9
7: Vamp...12.6
8: GND...0
9: GND...0
10: GND...0
11: B5V...5.3
12: A5V...5.3
13: B5V...5.3
14: POWER ON/OFF...3.5
These are my voltages with the all boards plugged in:
1: B13V...12.6
2: PWM_DIM...jumps constantly from 0-2.2
3: B13V...12.6
4: B13V...12.6
5: Vamp...12.6
6: BLU_ON/OFF...4.9
7: Vamp...12.6
8: GND...0
9: GND...0
10: GND...0
11: B5V...5.3
12: A5V...5.3
13: B5V...5.3
14: POWER ON/OFF...3.5
So as far as I could tell, the only thing that differs between plugging the T-Con into the main board is that PWM_DIM goes crazy which would explain the back lights flickering.
Would this point to a main board fault or a power board fault. I'm hoping it's not the T-Con at this point. The guy that worked on it said he is 100% sure it works, based on his reviews I'd like to believe him.
These are my voltages with the T-Con unplugged from the main board:
1: B13V...12.6
2: PWM_DIM...2.9
3: B13V...12.6
4: B13V...12.6
5: Vamp...12.6
6: BLU_ON/OFF...4.9
7: Vamp...12.6
8: GND...0
9: GND...0
10: GND...0
11: B5V...5.3
12: A5V...5.3
13: B5V...5.3
14: POWER ON/OFF...3.5
These are my voltages with the all boards plugged in:
1: B13V...12.6
2: PWM_DIM...jumps constantly from 0-2.2
3: B13V...12.6
4: B13V...12.6
5: Vamp...12.6
6: BLU_ON/OFF...4.9
7: Vamp...12.6
8: GND...0
9: GND...0
10: GND...0
11: B5V...5.3
12: A5V...5.3
13: B5V...5.3
14: POWER ON/OFF...3.5
So as far as I could tell, the only thing that differs between plugging the T-Con into the main board is that PWM_DIM goes crazy which would explain the back lights flickering.
Would this point to a main board fault or a power board fault. I'm hoping it's not the T-Con at this point. The guy that worked on it said he is 100% sure it works, based on his reviews I'd like to believe him.
Comment