So I had a DC jack repair, but it was difficult removing the old jack. I couldn't do it with my 25w wellers pencil iron. Board dissipate my heat really well.
I had to use a non-grounded made-in-china 40 watt iron I had laying around with a really BAD tip, I mean I think it had broken off and my dad used a bench grinder to it.
This is third time my wellers wasn't able to do the job.
So I think it's time to upgrade.
I really like my wellers EC3000 with an EC1301 iron attachment. Does fine with most stuff but sometimes I need a little more heat and quicker in-out before I start burning tracks off.
What would you guys recommend?
Also must have interchangeable tips and have a chisel/flatblade tip attachment.
I had to use a non-grounded made-in-china 40 watt iron I had laying around with a really BAD tip, I mean I think it had broken off and my dad used a bench grinder to it.
This is third time my wellers wasn't able to do the job.
So I think it's time to upgrade.
I really like my wellers EC3000 with an EC1301 iron attachment. Does fine with most stuff but sometimes I need a little more heat and quicker in-out before I start burning tracks off.
What would you guys recommend?
Also must have interchangeable tips and have a chisel/flatblade tip attachment.
Comment