Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]

Announcement

Collapse
No announcement yet.

please help identify part test/replacement

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    please help identify part test/replacement

    im want to test this part, and replace it if it's bad.. it's off of "soyo topaz S" power supply,
    http://*************/photo/my-images/713/111ytk.jpg
    http://*************/photo/my-images/215/222ndj.jpg
    http://*************/photo/my-images/20/333fp.jpg

    i have tested the pins, they are all open and show no resistance except for the side A, pins 1-4 and 2-5 both 0.3ohm
    sideA[123-45]
    sideB[1-23]

    i appreciate any info, thank you
    Tags: None
    #2
    Re: please help identify part test/replacement

    I believe that is a transformer, but from what I can tell that might not be the problem with this particular power board. look herez

    http://slickdeals.net/f/1655449-Solv...r-supply-board

    also look and see if its main cap (the big one) is bulged. Its surrounded by one of the main heatsinks on that board and the heat usually seems to kill it
    Cap Datasheet Depot: http://www.paullinebarger.net/DS/
    ^If you have datasheets not listed PM me

    Comment

      #3
      Re: please help identify part test/replacement

      Originally posted by Uranium-235 View Post
      I believe that is a transformer, but from what I can tell that might not be the problem with this particular power board. look herez

      http://slickdeals.net/f/1655449-Solv...r-supply-board

      also look and see if its main cap (the big one) is bulged. Its surrounded by one of the main heatsinks on that board and the heat usually seems to kill it
      yeah i already replaced the big cap, it was bulged, also replaced the fuze, it was burned out, but it keeps burning out my fuze every time i plug it in, i will try to find and test the diode, thank you

      Comment

        #4
        Re: please help identify part test/replacement

        i took out the zd1 diode, it measures 0.055nF, one way, and 19.35mohm one way, does this look ok?

        Comment

          #5
          Re: please help identify part test/replacement

          Another thread in here with this part:

          https://www.badcaps.net/forum/showthread.php?t=8729

          Seriously doubt it's the transformer that's the problem...
          veritas odium parit

          Comment

            #6
            Re: please help identify part test/replacement

            yup i read that thread, unfortunately it went nowhere, i keep trying to locate the faulty part but i don't have much electronics knowledge, but i know how to use a multimeter lol

            Comment

            Previous template Next
            Working...
            X